11
JCB-ID1050
Instruction & User Manual
OPERATING INSTRUCTIONS
Intended Use
This impact driver is intended for drilling in
stone, wood, metal, ceramics and plastics and
percussion drilling in brickwork, concrete and
stone.
The drill driver must not be modified or used
for any other purposes than the ones described
in these instructions.
Attaching the Side Handle
m
Push the side handle over the drill chuck and
screw into place.
Setting The Depth Stop
m
Loosen the fixing securing the depth stop.
m
Adjust the depth stop to the required offset.
m
Tighten the fixing, ensuring the depth stop is
securely fastened in place.
Replacing Bits/Drills
Never hold the chuck sleeve in one hand
and run the tool to tighten or release
accessories. This risks serious personal injury.
WARNING!
Tool accessories can be very sharp and can
become very hot during use - risk of
personal injury.
WARNING!
m
Open the chuck by holding the chuck sleeve
in a firm grip and turning it anticlockwise
until the chuck jaws open and the accessory
can be inserted. The chuck is designed so
that it can easily be tightened or released
with one hand.
The spindle locks automatically when the
chuck stops rotating.
NOTE
m
Insert the accessory as far as it will go into
the chuck. Point the tool up a bit, so that the
accessory does not fall out.
m
Tighten the chuck sleeve clockwise so that
the accessory is clenched between the
chuck jaws.
Check that the accessory is straight, centred
and not skew. If the accessory is not properly
positioned it could fly out when starting the
tool. Check that the chuck jaws rest on the
flat surfaces of the accessory.
NOTE
m
Tighten the chuck all the way. Grip the
chuck firmly and turn it clockwise.
m
Tighten the rear sleeve of the tool mount
using the drill chuck key.
Power Switch
m
Press the power switch to start the tool.
The tool has variable speed, a lock button for
constant use, and a maximum speed selection
dial:
Variable Speed
m
Press the power switch to increase the
speed.
m
Release it a little to reduce the speed.
m
Release the power switch to stop the tool.
