![background image](http://html2.mh-extra.com/html/jcb/jcb-hd900-2/jcb-hd900-2_operating-manual_3553919013.webp)
JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0333 0143092
WORKING HINTS FOR YOUR HAMMER DRILL
If your power tool becomes too hot, set the speed to maximum and run no load for
2-3 minutes to cool the motor. Tungsten carbide drill bits should always be used
for concrete and masonry. When drilling in metal, only use HSS drill bits in good
condition. Always use a magnetic bit holder when using short screwdriver bits.
Where possible use a pilot hole before drilling a large diameter hole.
MAINTENANCE
Remove the plug from the socket before carrying out any adjustment,
servicing or maintenance.
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use water or
chemical cleaners to clean your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor ventilation slots clean. Keep
all working controls free of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage your power tool. If the supply
cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist. Check with your local
authorities or retailer for recycling advice.
Содержание JCB-HD900-2
Страница 2: ......