SO53 3LE
Customer Helpline
0845 600 5526
SO53 3LE
Customer Helpline
0845 600 5526
loosen a very tight screw or
continue working when the battery
energy has expired. For manual
screwdriver purposes, the chuck is
automatically locked when the tool
is off.
8. uSing tHE LED LigHt
To turn on the light simply press the
on/off switch. When you release the
on/off switch, the light will be off.
LED lighting increases visibility-
great for dark or enclosed area. LED
is also a battery capacity indicator. It
will flash when power gets low.
9. DRiLLing
When drilling into a hard smooth
surface, use a center punch to mark
the desired hole location. This will
prevent the drill bit from slipping off
center as the hole is started. Hold
the tool firmly and place the tip of
the bit at the point to be drilled.
Depress the switch trigger to start
the tool. Move the drill bit into the
workpiece, applying only enough
pressure to keep the bit cutting. Do
not force or apply side pressure to
elongate a hole.
tungsten carbide drill
bits should always be
used for concrete and masonry.
when drilling in metal, only use
HSS drill bits in good condition.
always use a magnetic bit holder
(not included) when using short
screwdriver bits. when screw-
driving, apply a small quantity of
liquid soap or similar to the screw
threads to ease insertion.
10. DiSPOSaL Of an
EXHauStED BattERy
PaCK
To preserve natural resources,
please recycle or dispose
of the battery pack properly.
This battery pack contains Lithium
batteries. Consult your local waste
authority for information regarding
available recycling and/or disposal
options. Discharge your battery
pack by operating your drill, then
remove the battery pack from the
drill housing and cover the battery
pack connections with heavy-duty
adhesive tape to prevent short
circuit and energy discharge. Do not
attempt to open or remove any of
the components.
11. OvERLOaD
PROtECtiOn
When overloaded, the motor comes
to a stop. Relieve the load on the
machine immediately and allow
cooling for approx. 30 seconds at
the highest no-load speed.
12. tEMPERatuRE
DEPEnDEnt OvERLOaD
PROtECtiOn
When used as intended the power
tool cannot be subject to overload.
When the load is too high or the