5
FITTING ThE CARRYING
STRAp
To attach the carrying strap
‰
, locate the two
end plates of the strap into the holes provided
in the motor housing
fi
of the cleaner as
shown
A
. Secure the plates in position using
the two cross-head screws (provided), ensuring
the screws are tight.
The strap is adjustable to the user by sliding the
strap material through the buckle to adjust.
ChARGING ThE BATTERY
The product is supplied with the battery in a
low charge condition. Charge the battery for
16 hours before use. Do not charge in extreme
ambient temperatures, ie. below 0
o
C or above
40
o
C. After use, recharge for a maximum of 16
hours, avoid over-charging, do not leave the
product continuously on charge. If the product
is not being used for a while, recharge for 16
hours once per month to keep the battery
topped up.
IMPORTANT: Do not allow the battery
to be fully discharged. When the suction
becomes low, switch off and recharge the
battery.
Mains power charging adaptor
Ë
To charge using the mains power charging
adaptor
Ë
, plug the adaptor into a mains
socket outlet and switch the mains socket to
on, then locate the plug from the adaptor into
the charging jack
Â
in the vacuum cleaner
B
.
The red charging indicator light
‹
shows
charging is in progress, when the red light goes
out, the battery is fully charged.
In-car power charging adaptor
È
To charge using the in-car power charging
adaptor
È
, plug the in-car adaptor into the
cigarette lighter socket outlet and then locate
the plug from the adaptor into the charging jack
Â
in the vacuum cleaner.
NOTE:
With the vacuum cleaner
switch in the ON position, the
charger is disconnected from the
battery, so the battery will not
charge if the switch is in the ON
position. The charging adaptors are
not designed to run the motor in
the vacuum cleaner, they are only
designed to charge the battery.
The red charging indicator light
‹
shows
charging is in progress, but when using the
in-car power charging adaptor, it will not go out
when the battery is fully charged.
CAUTION!:
Leaving the vacuum
cleaner on charge for an extended
period without the car engine
running will drain the car’s battery.
Ideally charge whilst the car is in use.
USING ThE ClEANER
Connect the hose
„
to the cleaner and push
in until it locks into position
C
(to release the
hose, push the lock button
›
). Attach the
required accessory
‡ ·
or
‚
.
C
A
B
