jcb 6T-1 Front Tip, Руководство по обслуживанию

Страница: 18 / 51

01 - Machine
03 - Safety
27 - Maintenance Positions
01 - 12 9813/8950-2 01 - 12
27 - Maintenance Positions
Introduction .................................................... 01-12
Health and Safety .......................................... 01-15
Introduction
For: 6T-1 Front Tip, 7T-1 Front Tip [Hi-Viz],
9T-1 Front Tip ........................... Page 01-12
For: 6T-1 Swivel Tip .................. Page 01-13
(For: 6T-1 Front Tip, 7T-1 Front Tip [Hi-
Viz], 9T-1 Front Tip)
Dumper Body Lowered
1. Park the machine on level solid ground.
2. Lower the dumper body.
3. Apply the park brake.
4. Stop the engine and remove the ignition key.
5. Disconnect the battery to prevent accidental
operation of the engine.
6. If necessary, put blocks against the two sides
of the wheels before you get underneath of the
machine.
Dumper Body Raised
DANGER A maintenance strut or other method
of supporting the skip in the raised position must
be installed and locked in position before working
under a raised skip. Do not reach or work under
a raised skip unless a prop is installed.
If you raise the dumper to get access for
maintenance, you must install the maintenance strut
on the dumper body.
The maintenance strut is only for use with a empty
dumper.
Install
1. Discharge any material from the dumper and
then raise the dumper fully.
2. Stop the engine and remove the ignition key.
3. Remove the strut.
3.1. Release the fastener.
3.2. Remove the strut from its stowage bracket.
4. Install the strut on the lift ram. Refer to Figure 2.
4.1. Push the strut over the ram piston rod.
4.2. Secure the strut in position with strap.
5. Lower the dumper onto the strut.
5.1. Start the engine and slowly lower the
dumper onto the safety strut, stop the