26 - 3
Removal
1
Park the machine on firm level ground, engage the
parking brake and set the transmission to neutral.
Lower the loader arms to the ground.
2
Position the carriage centrally and rest the bucket on
the ground, remove the starter key.
3
Undo and remove nuts
B
.
4
Remove split pins
D
and pin
E
.
5
Withdraw chains from the machine.
Assembly
1
Thread the chains around the pulley and secure to the
carriage with pin
E
, fit new split pins
D
.
2
Connect chain adjusters, tension chains as required,
see
Check and Adjust
.
Power Sideshift - Chain Adjustment
The chain tension should be checked at the initial 100 hours
service and every 500 hours.
Check and Adjust
1
Park the machine on firm level ground, engage the
parking brake and set the transmission to neutral.
Lower the loader arms to the ground.
2
Position the carriage centrally and rest the bucket on
the ground, remove the starter key.
3
Check the chain tension which should be 5 to 10mm
(0.19 to 0.39in) deflection
A
at the mid point. The
tension should be equal for all chains.
4
If adjustment is required, slacken locknuts
C
and adjust
on nuts
B
as required, tighten locknuts
C
on
completion.
5
Repeat steps 3 and 4 for the opposite pair of chains.
Note
: When there is no thread left for adjustment fit new
chains.
6
Operate the carriage side to side several times and
recheck the deflection.
Section B
9803/3280
Section B
26 - 3
Issue 1
Service Procedures
A326830
B
B
A
C
C
D
D
E