14
21-CS1500
Instruction & User Manual
Parallel Cut Adjustment
m
Loosen the lock knob of edge guide.
m
Slide the parallel guide through the slots in
the shoe to the desired width.
m
Tighten the lock bolt to fit it in the position.
m
Ensure that the edge guide rests against
the wood along its entire length to give a
consistent parallel cuts.
Laser Line Generator
Do not stare directly at the laser beam, do
not deliberately aim the beam at personnel
and ensure that it is not directed towards
the eye of a person for longer than 0.25
seconds.
WARNING!
m
Turn on: Press the laser generator switch
once.
m
Turn off: Press the switch again.
m
Mark the cutting line on the work piece.
m
Adjust the angle of cut as required.
m
Plug in the machine and start the motor.
m
When the blade is at its maximum speed
(after approximately 2 seconds), place the
saw on the work-piece.
m
Switch on the laser generator from the laser
aperture using the laser generator switch.
m
Align the beam with the mark on the work-
piece and slowly push the saw forward using
both hands, keeping the red light beam on
the mark.
m
Switch off the laser beam when the cut is
completed.
General Cutting
m
When starting, always hold the saw handle
with one hand and the auxiliary handle with
the other hand. Never force the saw but
maintain a light and continuous pressure
after completing the cut allow the saw to
come to a complete stop. When cutting
is interrupted, resume cutting by allowing
the blade to reach full speed and then
reentering the cut slowly.
m
When cutting across the grain, the fibers of
the wood have a tendency to lift and tear,
moving the saw slowly minimizes this effect.
m
Use only saw blades recommended by
the manufacturer, which conform to EN
847-1, if intended for wood and analogous
materials.
m
Use only blade diameter(s) and speeds/
specifications etc in accordance with the
rating plate of the product.
Pocket Cutting
m
Disconnect the plug from the power supply
before making any adjustments. Set the
depth adjustment based on the thickness of
the line drawing for the cut. Raise the lower
guard by using the lift lever.
m
With the blade barely above the material
to be cut, start the saw and allow the blade
to come to full speed. Gradually lower the
blade into the material to be cut using the
front end of the shoe as a pivot point.
m
When the blade starts cutting, release the
lower guard.
m
When the shoe is resting flat on the surface
being cut, proceed cutting in a forward
direction to the end of the cut.
m
Allow the blade to come to a full stop
before removing it from the cut.
