jcb 20BLDD, Инструкции и руководство пользователя

Страница: 17 / 22

17
JCB-20BLDD
Instruction & User Manual
m
Press the bit firmly against the screw and
drive in the screw.
m
Once the screw is sufficiently tightened,
release the power switch
before you stop
pressing in the screw, otherwise you can
damage the screw or screw head. The
bit or tool can be damaged if you do not
release the power switch immediately.
To unscrew/loosen screws:
m
Set the rotation selector to anticlockwise
rotation.
m
Place the bit into the screw head in line with
the screw. Otherwise the screw can be
damaged.
m
Press the bit firmly against the screw and
loosen the screw.
Gearbox Speed Selector Switch
Only use the Gearbox Speed Selector
Switch (4) when the power tool is stopped
and the chuck is not rotating. Otherwise the
power tool can be damaged.
WARNING!
m
Move the gearbox speed selector switch
away from the chuck to position 1 for low
speed (0 to 350rpm).
m
Use the low speed mode for screw driving
and for drilling holes with a large diameter.
m
Move the Gearbox Speed Selector Switch
(4) forwards towards the chuck to position
2 for high speed (0 to 1200 rpm).
m
Use the high speed mode for drilling small
holes.
Maintenance
Switch off the power tool and disconnect
the power (remove battery/unplug) before
cleaning and maintenance. This helps avoid
the risk of electric shocks and accidental
starting.
WARNING!
m
Wipe the power tool with a dry or damp
cloth.
Do not use a wet cloth. Do not
use detergent that contains solvent
or corrosive, abrasive additives.
This
risks damaging the surfaces of the tool.
m
Clear the power tool vents and the chuck of
dust and dirt after each use.
Do not clean
ventilation holes by inserting sharp
objects in them, such as screwdrivers
and other similar objects.
m
Stubborn contamination in areas hard to
access can be removed with compressed air
(max 3. bar).
m
Regularly check all fasteners, screws and
bolts to make sure that they are tight.
Tighten any loose screws immediately or
serious injury could occur.
Never open the power tool. The power
tool has no internal parts that the user can
service or repair. Never try to repair the
power tool yourself. Take to an authorised
service centre.
WARNING!
Transport and Storage
m
If the power tool will remain unused for any
length of time, it should be stored in the
original packaging.
All manuals and user guides at all-guides.com