JBO eMultiCheck, Инструкция по эксплуатации

Страница: 10 / 15

9
4.1.1 Pattern of movement
Different patterns of movement can occur during the setting process. These are characterised by:
(left-hand rotation)
1. One short turn 1st hole is the next hole
2. Two short turns 2nd hole is the next hole
3. Three short turns 3rd hole is the next hole
4. Alternating left/right-hand turns at short intervals measuring error
In the event of a measuring error (4) the turning pattern for the next hole is displayed again.
4.1.2 Torques
In the relevant standard, there are no fixed torques determined for testing threads. The only
specification is "screw in with light manual force“. The table below shows the torques with
recommendations for a thread size. However, in the end there are many influences that make it
necessary to adapt the torque (material, tolerance range of the thread, etc.).
Please note: fluctuations in torque can occur due to temperatures and motor tolerances.
Level Torque Ncm
Thread range
metric from
to
1 10
2 12 1,6 3,5
3 15 4 5,5
4 16 6 8
5 17 9 13
6 18 14 29
7 20
8 25
9 30
Table 1: Recommended torques