Auto On/Standby
The JBL On Air WEM-1 will automatically enter the Standby mode after approximately 10
minutes, when no signal is detected from your system. The WEM-1 will then power on instantly
when a signal is detected. When Mute is engaged, auto turn-off is deactivated.
Normal Operation (Input on Transmitter used)
LED Color
Transmitter Module Receiver
Module
Green
Transmitter and receiver module
are communicating (RF lock)
Transmitter and receiver module
are communicating (RF lock)
Blinking Green (Slow)
Transmitter and receiver are
not communicating (no RF lock)
Transmitter and receiver are
not communicating (no RF lock)
Blinking Green (Fast)
Not applicable
Receiving IR command from
remote control *
Red
Standby (no signal being received) Standby (no signal being received)
Local input Used on Receiver
LED Color
Transmitter Module Receiver
Module
Orange
Not applicable
Local input is selected
Blinking Orange (Slow)
Not applicable
System muted
Blinking Orange (Fast)
Not applicable
Receiving IR command from
remote control *
* Blinking stops when unit reaches minimum or maximum volume setting
Subwoofer Output
The JBL On Air WEM-1 includes a subwoofer output _on the receiver module.
This output allows you to feed the low-frequency sounds to a separate powered subwoofer. A
powered subwoofer will deliver deeper bass response than is possible with speakers alone.
To connect a powered subwoofer to the receiver module, simply connect the
Sub Out _on the receiver module to the line-in on the rear of the powered
subwoofer, using a 1/8-inch stereo mini-jack/RCA cable (not included). Please
note that this output is full-range and not filtered or low-passed. Make sure that
your powered subwoofer features a low-pass crossover network and that this
crossover is indeed selected. Do not use the LFE input on a powered subwoofer,
as it is not filtered and you will be hearing a lot of undesirable higher-frequency
information from your subwoofer.
A Word About Wireless Products
The JBL On Air WEM-1 utilizes advanced wireless transceivers operating in the 2.4GHz
frequency band. This is the same frequency band that is used for wireless home networks and
high-quality cordless phones. It also allows the transmission of high-performance, full-spectrum
sound to remote locations, wirelessly.
Like all wireless devices, the WEM-1 wireless speaker’s operating range may vary, depending
upon variables such as building construction methods and materials, atmospheric conditions
and other sources of interference. Please consult your JBL dealer or distributor, or visit
www.jbl.com, for further information or assistance.
6
On Air WEM-1