JBL SYNTHESIS SDA4600, Руководство по установке системы

Страница: 8 / 16

8 | J B L S y n t h e s i s S D A 8 3 0 0 / S D A 4 6 0 0 S y s t e m G u i d e
SDA4600 (SINGLE)
SDA8300 (SINGLE)
CONFIGURATION 1 AMP CHANNEL
SUB 1 1
SUB 2 2
SUB 3 3
SUB 4 4
Factory Default Configuration 1
Nothing should be done to the amplifier. It is factory set to this
configuration. DO NOT INSTALL ANYTHING INTO THE GPIO INPUT. If you
accidentally insert the Configuration Trigger and need to reset the unit,
contact Technical Support for Step by Step Instructions,
csupport@harman.com or toll free at +1 (888) 691-4171.
Step Five – Configuration and Identification
SDA4600 4 x 600 Watts per channel
Configuration 1 is the default factory settings are for use with a single
SDA8300. This is configuration 1. If you are using these factory default
outputs no configuration is needed, and doing so will cause the units to
operate incorrectly. If you accidentally select one of the alternate
configurations below you will need to contact JBL Synthesis Technical
Support to reset the unit.
Use with these subwoofers:
Any passive subwoofer with a power handling of 200 – 600 Watts
S4S
S2S
S2S-EX (WITH SYN-THREE-ARRAY OR SMALLER LCR SPEAKERS)
5