EN-14
Bridged Mono Mode – SDA-2200 Only
Bridged mono mode requires the use of a SDA-2200 for
each channel.
Note:
In bridged mode only the
L+
and
R+
speaker
outputs are required.
WARNING: Do not make any connections to the L- or
R- speaker terminals, doing so will severely damage
your amplifier.
On one of the SDA-2200’s, connect the
RED
positive
speaker terminal labelled
L+
to the positive terminal of
your left speaker.
Connect the
RED
positive speaker terminal labelled
R+
to the negative terminal of your left speaker.
Repeat this process for the right speaker, using the
SAME
terminals on the other SDA-2200.
In this setup only one interconnect is required to
each power amplifier and it should be connected to
the
IN L
input. The interconnects can be either XLR
(recommended for longer cable runs) or phono (RCA).
Set the
INPUT
switch on both of the SDA-2200’s to the
appropriate setting for the cables used.
Note:
The
IN R
input has no function in this
arrangement.
Note:
L+
must be connected to the positive speaker
terminal and
R+
to the negative speaker terminal on
BOTH
speakers otherwise the speakers will be out of
phase.
WARNING: Make ABSOLUTELY sure you have used
the L+ and R+ terminals of the SDA-2200. L- and R-
terminals are NOT required in this arrangement.
HF
LF
HF
LF
Right
Left
Note:
Make sure INPUT switch is set to
input type RCA or XLR
Make sure GAIN switch is set to
31dB
Make sure MODE switch is set to
bridged mode, BRIDGE
Contains Transmitter module
FCC ID: APILUXASTR01
IC: 6132A-LUXASTR01
Contains Transmitter module
FCC ID: APILUXABT01
IC: 6132A-LUXABT01
SDP-55
Note: Unit should be connected via
RCA or XLR. Both versions shown for
illustrative purposes only.
SDA-2200
SDA-2200
