JBL SUB125, Руководство по обслуживанию

Страница: 10 / 20

Service Bulletin JBL9901
To: All JBL Service Centers - January 1999 This is considered a Minor repair
Model: Sub125 (SCS125 Powered Subwoofer)
Subject: Amplifier plate overheating; Blown fuses
In the event you receive a Sub125 (SCS125 Powered Subwoofer) with the complaint “amplifier plate is getting too
hot”, or “the unit is blowing fuses”, perform the necessary steps listed below to change the bias current of the
amplifier. This procedure should be performed on all Sub125 amplifiers being serviced for any reason:
1. Set the subwoofer cabinet on a padded surface with amplifier facing upwards.
2. Remove the (14) Philips screws holding the amplifier and inner plastic cover to the cabinet. Four of these 14
screws are in each corner, slightly larger and just inside the smaller corner screws.
3. Remove amplifier assembly carefully . Do not pull the amplifier out of the cabinet too much; it can disconnect
the speaker wires. (The amp assembly can be laid on one corner of the cabinet for the remainder of the
procedure without disconnecting the speaker wires).
4. Carefully pry plastic cover off amplifier assembly. If you are too aggressive Molex connector P104 may be
damaged; speaker wire inside the cover has little extra length. Lift the left side of the cover first to avoid
disconnecting the cable at P104; this connector is located on the right side of the plate inside the cover.
5. Once the cover is pulled back, locate VR101. See Figure 1.
6. Using a thin Phillips screwdriver 5 or more inches long, set trim pot VR101 to Full CCW position (Minimum
level). Be gentle to avoid damage to the part.
7. If necessary, replace blown line fuse with h/k part# FS1067, (2A Slo-Blo 5 x 20mm GMC type).
8. Replace the amplifier in the cabinet; replace all (14) screws to secure the amplifier plate and plastic cover.*
9. Functional Test - Set the LEVEL control to minimum (Full CCW). Connect an AC Wattmeter to the AC input
line and turn the unit ON; maximum AC measured power should not be more than 12.5 watts.
10. Connect music signal from a CD source and increase volume to a medium level to verify sound from the
subwoofer. Do not increase volume to a point where the unit is driven into clipping. No evidence of distortion
and/or rattle inside the box should occur.
11. Conduct warm-up for 10 minutes; turn LEVEL control Full CCW or remove signal. Input power as measured
by AC Power meter should not exceed 13 watts. If value exceeds this, re-check pot. VR101 position if
necessary.
12. Add an adhesive label (dot) to the amplifier plate with the letter “a” written on it; if the customer’s outer carton
is available, add an “a” with a marker to the “SCS125” printing on the carton in all places where it appears.
Unmodified
Sub125 (SCS125
Subwoofer)
Factory Modified
Sub125a
(SCS125 Subwoofer)
Orange Label on
amplifier plate: This area is
designed to become quite
warm during normal
operation
Outer carton
marked SCS125
Outer carton
marked SCS125a
* Alternately, the amplifier may be driven out of
the cabinet by attaching a 4 ohm 25 watt load
resistor to the output terminals, and using a 50 Hz
sine wave input signal adjusted to achieve 7 volts
at the load resistor for the warm-up test.
1 0
Amplifier/Subwoofer SUB125