6
jbl on stage III
WM remote easy setup guide
Volume Down
“Walkman” Play/Pause
“Walkman” Rewind/ Previous
“Walkman”
Volume Up
Mute/Unmute
1. In the battery-only mode, the JBL On Stage III WM loudspeaker dock will
turn off to save battery power when muted or paused for longer than 10
minutes.
2. In the wall adapter power supply mode, the JBL On Stage III WM will go
into standby mode if no audio signal is detected for 10 minutes. Once an
audio signal is detected, the speaker will return to normal playing mode.
“Walkman” Next/Fast
Forward
“Walkman” Folder –
Navigation Control Mode
Turn “Walkman” on:
Press the Play/Pause button on the remote control to wake the
“Walkman”.
Press the button.
Folder –
Press the Folder – button.
Music Control Mode
Play a track:
Press the Play/Pause button.
Pause a track:
Press the Play/Pause button while a song is playing.
Skip to next track:
Press the Next/Fast Forward button.
Skip to previous track:
Press the Rewind/Previous button twice within two
seconds.
Fast-advance track:
Press and hold the Next/Fast Forward button.
Fast-reverse track:
Press and hold the Rewind/Previous button.
Increase volume:
Press the Volume Up button.
Decrease volume:
Press the Volume Down button.
Mute:
Press the Mute/Unmute button.
JBL Remote Control Technical
Specifi cations
Transmission:
IR
Frequency:
38kHz
Operating Range:
20 feet(6 meters)
Battery Type:
CR2025 3V
Dimensions:
Width:
1.29"(33mm)
Height:
3.38" (86mm)
Depth:
0.23" (6mm)
Weight (including battery):
1.2 oz.
Remote Control Battery Installation Instructions
1. Remove battery-compartment cover.
2. Insert a 3-volt 2032 type battery, positive side up.
3. Replace battery-compartment cover.
