1.5 m–1.8 m
MODEL: E30
SPEAKER PLACEMENT
Proper placement of the speak-
ers is an important step in
obtaining the most realistic
soundstage possible. These
recommendations are for the
optimum placement of the loud-
speakers. Use these placement
recommendations as a guide.
Slight variations will not
diminish your listening pleasure.
All of the Northridge E Series
loudspeakers referred to in this
guide are video-shielded and
can safely be placed near a
television.
As front speakers
Speakers and electronics termi-
nals have corresponding (+) and
(–) terminals. It is important to
connect both speakers identi-
cally: (+) on the speaker to (+)
on the amplifier and (–) on the
speaker to (–) on the amplifier.
Wiring “out of phase” results in
thin sound, weak bass and poor
imaging.
To use the binding-post speaker
terminals, unscrew the colored
collar until the pass-through
hole in the center post is visible.
Insert the bare end of the wire
through this hole; then screw
the collar down until the con-
nection is tight.
The hole in the center of each
collar is intended for use with
banana-type connectors. To
comply with European CE certi-
fication, these holes are
blocked with plastic inserts at
the point of manufacture. To use
banana-type connectors
requires the removal of the
inserts. Do not remove these
inserts if you are using the
product in an area covered by
the European CE certification.
BI-WIRING
The bi-wire connection method
requires one amplifier and two
sets of speaker wires. By
removing the shorting bars,
connections may be made to
the individual network sections
using four conductors, one for
each of the four terminals.
For single-wire connection,
leave the shorting bars in place
and connect only a single set of
speaker wires (two conductors)
to the two upper terminals.
Bi-Wire Connections
– +
– +
– +
Amplifier
High Frequency
Low Frequency
SPEAKER CONNECTIONS
– +
– +
– +
Receiver’s Speaker Outputs
LEFT
LEFT
RIGHT
RIGHT
– +
MODELS: E60, E80, E90
As surround speakers
All manuals and user guides at all-guides.com
