145x210mm
2
Wiring identification
Installation Notes
Applicable to both 2 and 4-speaker connection:
A. Connections
B. Din cable connection for remote control
C. Din cable connection for SIRIUS control
D. AUX-IN
E. Antenna socket
This radio contains four separate power amplifiers. To prevent possible damage to
these amplifiers please ensure the following:
i) The boat chassis is not used as a loudspeaker ground(-).
ii) Front and rear loudspeaker connecting wires are not joined together.
iii) Any wires not used when completing a two speaker installation are fully insulated.
iv) The memory wire (yellow) is connected to a per 12V supply.
v) The power wire (red) is connected via the ignition switch of the boat.
CONNECTOR
(AUTO ANT)
( BACK-UP B+ )
FUSE
1A
( GROUND )
FUSE
( IGNITION B+ )
Blue
Yellow
Black
Red
Gray
Gray/Black
Violet
Violet/Black
( Front Right )
( Rear Right )
Green
Green/Black
White
White/Black
( Front Left )
( Rear Left )
10A
Red
White
Black
White
(ANT. socket)
A
Red
Gray
Rear Line out
Front Line out
B
C
D
E
( Remote control )
( SIRIUS control )
( AUX-IN )
11
Precautions and maintenance
1. Reset function
A microprocessor reset button has been provided to facilitate manual resetting of the
internal microprocessor in the unlikely event that the player fails to operate correctly.
Should it be necessary to reset the microprocessor, simply open the face, remove
rubber plug and press reset button.
Note:
It will be necessary to re-enter the radio preset memories as these will have
been erased when the microprocessor is reset. After resetting the player, ensure
that all functions are operating correctly.
2. General Precautions
If the unit has become extremely hot we strongly recommend that you allow it to cool
down before using. Take care of your CDs to preserve the quality of the recording.
Do not allow them to be exposed to direct sunlight. Store them in a place protected
from dirt and dust and avoid handling them with oily, greasy or wet hands.
Be sure the CD is put into the CD slot label side up.
CONNECTOR PIN:
Always keep connector pin clean.
If the PIN connector looks dirty, use cotton tips to clean it, so as to avoid any
unexpected malfunction caused by dirt.
3. Caution
Connector pin
Reset button
CD slot
Front panel
CD eject button
