4
9
Important notes
Connecting the Speakers and Power Cables
Before you wire your system, disconnect your boat battery's positive (+) cable.
This helps prevent damage in case of a short. When you complete the wiring,
reconnect the battery cable and test your marine stereo. When connecting your
marine stereo's black ground wire, be sure to connect the wire to a metal part of
your boat or preferably to the negative (-) terminal of the boat battery.
POSITIVE
CHASSIS
NEGATIVE
CHASSIS
Prior to the final installation, perform a sound check. If high distortion or intermittent
sound is experienced, it is possible that the wiring from the receiver to the boat's
electrical system is poor or that the battery needs recharging.
If the battery and its charging circuit are OK, then rewire the yellow fused wire of the
receiver
directly to the positive terminal (+) of the boat battery.
Marine accessory shops stock the connector blocks and the 10 Amp cable that may
be necessary for extending the fuse wire connection.
Make sure that the black wire on the wiring harness is connected to a good ground
point on the boat. If the chassis of the boat is used as a grounding point, make sure
that the surface is scraped clean of paint before attaching the wire to it.
It is preferable to connect the black ground wire directly to negative terminal (-) of
the boat battery.
This model is only suitable for use in boats which have a Negative ground system,
e. g. : the negative terminal of the boat battery is connected to the chassis.
Grounding
Warning: polarity...
Station Tuning
1
5
7
9
11
13
3
2
6
8
10
12
14
4
16
15
1. Radio Operation
2. To Select Band
3. Manual / Seek tuning button (15)
4. Manual Station store
5. A.PS - Auto Store function (13)
6. Scan function (11)
7. Program Memory Scan
Press MOD button (3) to select Radio mode. Station frequency is indicated on display.
Press BD/FN button (4) to toggle through radio modes as follows:
FM1 --> FM2 --> FM3 --> AM1 --> AM2 --> FM1.
Press this button quickly to activate the Seek mode. The Seek mode will automatically
seek up or down the wave band and stop at the next station of sufficient signal strength.
Press and hold tuning button for 2 seconds to enter manual tuning mode. The unit will
revert back to Seek mode after 10 seconds without use.
Select the desired band and tune to a radio station to be memorized. Choose the preset
button memory location span 1-6 into which the station is to be stored and press and
hold that preset button for 2 seconds.
The station will now be entered into the preset memory. 6 stations can be memorized
on each of the FM1, FM2, FM3, AM1, AM2 bands.
Press and hold A.PS button for approximately 2 seconds until you hear a beep which
confirms the memory function is engaged. The unit will SEARCH for six strong stations
and automatically store them on buttons 1 - 6. (FM/AM only)
You can override the preset station on any button by manually setting a new frequency.
In Radio mode, press the SCAN button to scan strong stations. At the desired station press
the SCAN button again to stop scanning.
Momentarily press A.PS and the unit will scan for stored stations.
Momentarily press it again to stop scanning.
