JBL Horizon 2, Руководство по обслуживанию

Страница: 3 / 35

2.
Safety Instruction, Warning & Notes
RISK OF ELECTRIC SHOCK.DO NOT OPEN
THE LIGHTNING FLASH WITH AN ARROWHEAD SYMBOL,WITHIN AN EQUILATERAL
TRIANGLE,IS INTENDED TOALERT THE USER TO THE PRESENCEOF UNINSULATED
DANGEROUS VOLTAGE WITHIN THE PRODUCT’S ENCLOSURETHAT MAY BE OF
SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO
ALERT THE USER TO THE PRESENCE OF IMPORTANT OPERATING AND
MAINTENANCE(SERVICING)INSTRUCTION IN THE LITERATURE ACCOMPANYING THE
PRODUCT.
WARNING:TO REDUCE THE RISK OR ELECTRIC SHOCK,DO NOT EXPOSE THIS APPARATUS TO RAIN OR
MOISTURE.
CAUTION FCC AND ICSTATEMENT FOR USERS (USA AND CANADA ONLY)
This device complies with part 15 of the FCC Rules.Operation is subject to the following two conditions:(1)This device
may not cause harmful interference,and(2)this device must accept any interference received,including interference
that may cause undesired operation.CAN ICES-3(B)/NMB-3(B)
FCC SDOC SUPPLIER’S DECLARATION OF CONF ORMITY
HARMAN International hereby declares that this equipment is in compliance with the FCC Part 15 Subpart B.
The declaration of conformity may be consulted in the support section of our Web site,accessible from www.jbl.com
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part 15 of
the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a
residential installation.This equipment generates,uses and can radiate radio frequency energy and,if not installed and
used in accordance with the instructions,may cause harmful interference to radio communications,However,there is
no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful
interference to radio or television reception,which can be determined by turning the equipment off and on,the user is
encouraged to try to correct the interference by one or more od the following measures:
·
Reorient or relocate the receiving antenna.
·
Increase the separation between the equipment and receiver.
·
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
·
Consult the dealer or an experienced radio/TV technician for help.
Caution:
Changes or modifications not expressly approved by HARMAN could void
the user’s authority to operate the equipment.
For Products That Transmit RF Energy
FCC AND IC INFORMATION FOR USERS
This device complies with Part 15 of the FCC rules and Industry Canada license-
exempt RSS standars(s).
Operation is subject to the following two conditions:(1)This device may not cause
harmful interference;and (2)this device must accept any interference
received,including interference that may cause undesired operation.
FCC/IC Radiation Exposure Statement
This equipment complies with FCC/IC RSS-102 radiation exposure limits set forth
for an uncontrolled environment.
For Wi-Fi 5G device
FCC Caution
High power radars are allocated as primary user of the 5.25 or 5.35 GHz and 5.65 to
5.85GHz bands.These radars stations can cause interference with and/or damage
this device.
No configuration controls are provided for this wireless equipment allowing any
change in the frequency of operations outside the FCC grant of authorization for US
operation according to Part 15.407 of the FCC rules.
IC Caution
User should also be advised that:
(i)The device for operation in the band 5150-5250MHz is only for indoor use to
reduce the potential for harmful interference to co-channel mobile satellite
systems;(ii)the maximum antenna gain permitted for devices in the bands5250-
5250MHz and 5470-5725MHzshall comply with the e.i.r.p.limit:and (iii)The maximum
antenna gain permitted devices in band 5725-5825MHz shall comply with the
e.i.r.p.limits specified for point-to point and non point-to -point operation as
appropriate.
(iv)User should also be advised that high-power radars are allocated as primary
users(i.e.priority users)of the bands 5250-5350MHz and 5650-5850MHz and that
these radars could cause interference and/or damage to LE-LAN devices.
3
IMPORTANT SAFETY INSTRUCTIONS
For all products:
1. Read these instructions.
2. Keep these instructions.
3. Head all warning.
4. Follow all instructions
5. Do not use this apparatus near water
6. Clean only with a dry cloth
7. Do not block any ventilation openings ,Install this apparatus in accordance with the
manufacture’s instructions.
8. Do not install this apparatus near any heat sources such as radiators,heat registers, stoves
or other apparatus(including amplifiers)that produce heat.
9. Dot not defeat the safety purpose of the polarized or grounding-typeplug
.A polarized plug has two blades with one wider than the other..A grounding-type plug has two
blades and a third grounding prong.the wide blades or the third prong is provided for your safety.If
the provided plug does not fit into your outlet, consult and electrician for replacement of the
obsolete outlet.
10. Protect the power cord from being walked on or pinched,particularly at plugs.convenience
receptacles and the point where they exit from theapparatus.
11. Use only attachment/accessories specified by the manufacturer.
12. Use only with the cart,stand,tripod,bracket or table specified by the
manufacturer or sold with the apparatus.When a cart is used, use caution
when moving the cart/apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lighting storms or when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus
has been damaged in any way, such as when the power-supply cord or plug is damaged, liquid has
been spilled or objects have fallen into the apparatus, or the apparatus has been exposed to rain or
moisture, does not operate normally or has been dropped.
15. Do not expose this apparatus to dripping or splashing, and ensure that no objects filled with
liquids, such as vases, are placed on the apparatus
16. To disconnect this apparatus from the AC mains completely ,disconnect the power-supply
cord plug from the AC receptacle.
17. The mains plugs of the power-supply cord shall remain readilyoperable.
18. Do not expose batteries to excessive heat such as sunshine, fire or thelike.
19. This apparatus is intended to be used only with the power supply and/or charging cable
provided by the manufacturer.