JBL Harman PartyBox On-The-Go, Руководство пользователя, Страница: 15 / 15

15 15
www.jbl.com
English
11. COMPLIANCE
The product is in compliance with the European Union energy
legislation.
Bluetooth connection mode
The product is intended to be used for streaming music via
Bluetooth connection. A consumer can stream Bluetooth
audio to the speaker. When the product is connected through
Bluetooth, the Bluetooth connection must remain active at all
times to ensure proper operation.
The product will enter sleep mode (networked standby) after
20 minutes without operation. The power consumption in sleep
mode is less than 2.0 Watts, after which it can be re-activated
via Bluetooth connection.
Bluetooth disconnection mode
The product will enter standby mode after 20 minutes without
operation. The power consumption in standby mode is less than
0.5 Watts.
10. TROUBLESHOOTING
Caution:
– Never try to repair the product by yourself. If you have any
problems while using this product, check the following points
before you request service.
System
The speaker will not turn on.
• Ensure that the speaker battery is not drained. If not, use the
AC power instead.
No response from some buttons
• The product may be in demo mode. In demo mode, all the
input sources and buttons except / / / / are
disabled. Hold and simultaneously for more than 5
seconds to exit demo mode.
Sound
No sound from the speaker.
• Ensure that the speaker is powered on.
• Adjust volume.
• Ensure that a sound source is active and not muted.
Bluetooth
A device cannot connect with the speaker.
• Ensure that the Bluetooth function of the device is enabled.
• The speaker is already connected with another Bluetooth
device. Hold on the speaker for more than 20 seconds to
disconnect and pair with a new device.
Poor audio quality from a connected Bluetooth
device
• The Bluetooth reception is poor. Move the device closer to
the speaker, or remove any obstacle between the device and
speaker.
Wireless microphone
No response from the microphone.
• Power on the microphone.
• Replace batteries if the battery level is low.
• Pair the microphone with the speaker manually (see
6.5.1
Connecting a Microphone ).