JBL Control CRV, Руководство пользователя

Страница: 6 / 16

WALL CEILING MOUNTING
(Vertical Speaker Orientation)
When deciding upon a location for the JBL Control CRV
speaker, take care NOT to install the mounting bracket closer
than 3” (7.6 cm) to a side wall. Any closer than 3” (7.6 cm) will
not allow the clearance needed to position and slide the JBL
Control CRV speaker into the mounting bracket.
1. Run the wiring to the location desired for mounting the JBL
Control CRV speaker.
2. Attach the mounting bracket to the wall. Be sure to use
appropriate anchors.
3. Connect the stripped bare wires to the input terminals of the
JBL Control CRV speaker.
4. Set the tap selector switch to the desired 70V/100V tap, or to
the THRU position for 4 ohm low-impedance operation.
5. The mounting bracket is designed to trap the fl ange of the
JBL Control CRV speaker by securing the mounting-bracket
cap with two screws through the bottom of the mounting
bracket. Rest the JBL Control CRV speaker’s rear fl ange in the
mounting bracket, as shown. This will support the weight of the
speaker. Slide the mounting-bracket cap over the assembly.
Secure the mounting-bracket cap by inserting two #10-32 x 2”
screws (provided) in the bottom of the mounting bracket and
tightening.
INSTALLATION
3" Minimum
distance from wall
Appropriate
anchors
Top Cap
Mounting
Bracket
Mounting Bracket
shown as looking through
the speaker.
#10-32 x 2"
Screws (2)
This illustration shows
speaker viewed from
beneath.
Top Cap
Mounting
Bracket
#10-32 x 2"
Screws (2)
6
CAUTION: Installation must be
done by qualifi ed persons using
safe rigging standards
.
The installer is responsible for proper selection
and use of mounting hardware, to properly and
safely wall-mount the speakers.