Single Channel Tri-ampllficatlon
5 2 3 2 E L E C T R O N I C FREQUENCY D I V I D I N G NETWORK
PROGRAM
SOURCE
S h i e l d e d c a b l e is n e c e s s a r y f o r a l l i n p u t a n d o u t p u t c o n n e c t i o n s , a s
s h o w n . M a k e c e r t a i n t h a t t h e s h i e l d is p r o p e r l y c o n n e c t e d t o t h e
g r o u n d t e r m i n a l .
AMPLIFIER
AMPLIFIER
AMPLIFIER
LOUDSPEAKER SYSTEM
Operation
Verification Of System W i r i n g
It is imperative that each output
of
t h e electronic frequency
dividing n e t w o r k b e properly c o n n e c t e d . Inadvertent
exchange of l o w a n d high f r e q u e n c y output c o n n e c t i o n s —
at t h e network, power amplifiers o r t r a n s d u c e r s — m a y
result in severe damage to m i d r a n g e or high f r e q u e n c y
loudspeaker system c o m p o n e n t s .
The following procedure should be followed for each
program channel prior to operation.
1. With ail power off, set the High Frequency Level control at
" 2 " and adjust the program source level to minimum. (The
source material may be wide-band noise or music.) If the
power amplifiers are equipped with level controls, adjust
them to approximately one-quarter power.
2. Turn on the program source, network and amplifiers for the
channel under test.
3.
Gradually increase the program source volume level until
audible.
If the sound comes predominately from the midrange or
high frequency drivers, immediately shut power off and
check all wiring.
4.
If the low frequency loudspeaker produces bass, gradually
advance the High Frequency Level control.
Correct system wiring will be verified if the treble c o m -
^ ponent of the program material simultaneously increases in
level while coming from the midrange and high frequency
drivers.
Transducer Phasing
One important factor contributing to the natural sound
character of a loudspeaker system is the phase relationship of
the transducers for an octave below and above each cross-
over frequency. Two suitable methods for establishing proper
phase of the components in a two-way loudspeaker system
are described in the following paragraphs. Either one may be
used, depending on the availability of test equipment. A three-
or four-way system should be treated in a similar manner by
first establishing the proper phase for the transducers of the
low frequency transition and then progressing to the m i d - .
range, high frequency or ultra-high frequency transducers,
as applicable.
Objective Method—A
real time third octave analyzer, c o n -
denser microphone and a pink noise source can be used to
establish proper phase of the loudspeaker system c o m -
ponents as follows:
1. Using pink noise as program material, adjust system
volume for comfortable listening and set the levels of the
individual transducers to display flattest overall frequency
response on the real time analyzer.
2. Reverse polarity of the high frequency driver and observe
the effect on frequency response through the crossover
region.
Proper phasing of the transducers will have been achieved
when the flattest frequency response has been obtained
through the crossover region, as shown on the real time
analyzer.
5
5 2 3 2
H I G H
MID
LOW
F i g u r e 3.
The Wiring Diagram
