JBL 408GTI, Руководство по установке

Страница: 6 / 21

Mounting Instructions
Pick a mounting location after reading
the recommendations in the Component
Placement section of this manual.
Installing the GTi System
Crossover
The GTi system crossover should be
mounted securely to prevent damage to
the crossover or possible loosening of
wiring connections. Choose one of the
crossover mounting methods and follow
the directions below:
Mounting the GTi Crossover with Wire Ties
1.
Remove the crossover cover as shown
in Figure L.
2. Remove the crossover board from the
plastic case.
3. Use wire ties to secure the plastic case
to the desired location as shown in
Figure A.
4. Cut off the excess plastic on the wire ties.
5. Re-install the PCB and install wiring
from the crossover to the amplifier
and speaker locations as shown in
Figure K.
6. Re-install the crossover cover.
Mounting the GTi Crossover with Screws
1.
Remove the crossover cover as
shown in Figure L.
2. Remove the crossover board from the
plastic case.
3. Mark 4 hole locations, drill holes and
secure the bottom cover to the desired
mounting location as shown in Figure B.
Before starting make sure no electrical
or other critical car components are
located where you will be drilling.
4. Re-install the PCB and install wiring
from the crossover to the amplifier
and speaker locations as shown in
Figure K.
5. Re-install the crossover cover.
Note: Do not mount the GTi Crossover in a
location where it can get wet, as this
may cause damage to its components.
6
Figure C
Figure A
Figure B
MOUNTING RING
ADAPTER
WOOFER/
MIDRANGE
408/508 MANUAL.QXP 7/17/98 11:21 AM Page 6