JBL 404GTI, Руководство по установке

Страница: 7 / 16

Mounting the GTi Crossover with Wire Ties
1. Remove the crossover cover as
shown in Figure G.
2. Remove the crossover board from the
plastic case.
3. Use wire ties to secure the plastic case
to the desired location as shown in
Figure A.
4. Cut off the excess plastic on the
wire ties.
5. Re-install the PCB and install wiring
from the crossover to the amplifier
and speaker locations as shown in
Figure F.
6. Re-install the crossover cover.
Mounting the Crossover with Screws
1. Remove the crossover cover as
shown in Figure G.
2. Remove the crossover board from
the plastic case.
3. Mark 4 hole locations, drill holes and
secure the bottom cover to the
desired mounting location as shown
in Figure B. Before starting, make
sure no electrical or other critical car
components are located where you
will be drillling.
4. Re-install PCB and install wiring from
the crossover to the amplifier and
speaker locations as shown in Figure F.
5. Re-install the crossover cover.
Woofer/Midrange Driver
Mounting
Mounting to Stock Hole Locations
1.
Access the stock speaker location and
remove the stock speaker. The 404
and 504GTi include Intermount
TM
mounting ring adapters which
allow the speaker to be mounted
in standard 4" and 5
1 /
4
" holes
respectively.
2. Mount the intermount adapter plate to
the stock location using four #8 x 1
1 /
4
"
screws as shown in Figure C.
3. Attach the foam gasket to the back of
the woofer/midrange. Connect the
speaker wire from the crossover
terminals marked “W” to the
woofer/midrange terminals of the
speaker by either soldering (preferred)
or using crimp terminals. Connect the
“+W” terminal of the crossover to the
orange “W” terminal of the speaker.
Repeat for “–W” terminal.
7
Figure A Figure B
404/504 MANUAL.QXP 7/17/98 11:39 AM Page 7