ENGLISH
JBC reserves the right to after specifications without prior notice.
CHANGING THE TIP
Use the tip removal device Ref. 0114108.
1
Remove the ring to release the tip.
2
Remove the tip by pulling the soldering iron
lengthwise without forcing the element.
Before fitting the new tip, clean the part of
the element which is covered by the tip, to
eliminate any contamination and facilitate the
insertion of the new tip.
3
Insert the new tip and make sure that it has
penetrated fully home, otherwise its thermic
performance would be altered and would not
correspond to the temperature reading.
TIP CARE
- To clean the tips, use the damp sponge
included with the JBC stand. Only deionised
water (car battery watter) should be used in
order to wet the sponge. If normal water was
to be used, it is very likely that the tip will be-
come dirty due to the salts dissolved within
the water.
- Do not file the tips or use abrasive tools which
may damage the tip’s protective surface coat-
ing and avoid knocking them about.
- If the tip has been a long time with-
out being tinned, use the metal brush
Ref. 0297705 adaptable to the support, to
remove any dirt and oxide.
2
