jbc CS-F Series, Инструкция по эксплуатации

Страница: 9 / 24

OK
TOOL
EAR
THING FUSE
AUX
USE ONL
Y
WITH A 250
V FUSE
A
B
C360-001 C360-003
C360-007
C360-002
C360-004 C360-006
OK
TOOL
EAR
THING FUSE
AUX
USE ONL
Y
WITH A 250
V FUSE
A
B
C360-001 C360-003
C360-007
C360-002
C360-004 C360-006
OK
TOOL
EAR
THING FUSE
AUX
USE ONL
Y
WITH A 250
V FUSE
A
B
C360-001
C360-003
C360-007
C360-002
C360-004 C360-006
OK
TOOL
EAR
THING FUSE
AUX
USE ONL
Y
WITH A 250
V FUSE
A
B
C360-001 C360-003
C360-007
C360-002
C360-004 C360-006
OK
TOOL
EAR
THING FUSE
AUX
USE ONL
Y
WITH A 250
V FUSE
A
B
C360-001
C360-003
C360-007
C360-002
C360-004 C360-006
Desoldering Process
When desoldering, use a tip with a diameter larger than the pad being desoldered. This will achieve
maximum suction and thermal efficiency.
The vacuum pump will continue to run for a few seconds. This makes sure that the vacuum
circuit is completely empty. If there are any solder remains left on a terminal, just resolder it
with fresh solder and repeat the desoldering operation.
1.
Apply the tip so that it fits
over the component terminal.
2.
When the solder liquefies,
gently rotate the tip so that the
terminal can be lifted off.
3.
Then press the vacuum
pump button long enough to
suck up the solder.
Changing Heating Element
1.
Remove the filter before changing the
heating element.
2.
Remove the fixing screw and take out the
heating element.
Note:
For the following operations, turn off the station or disconnect the tool and wait until the
tool temperature drops to room temperature.
Desoldering Iron Maintenance
www.jbctools.com
9