CD-Q:
OK
CD-Q:
OK
CD-Q:
OK
Changing the Grips
Put the slide-on tabs into the
new grip.
Push the grip with the tabs
onto the handle.
Hold the grip and pull the tab.
Use a pliers if necessary.
tabs
new grip
Easily replace the grips using the slip-on tabs.
Note:
For the different handles are different grips avai-
lable.
1. Inserting Tabs
2. Inserting Handle
3. Removing Tabs
The sealing plug prevents undesirable flux vapors or particles from entering inside the tool. Its usage
is highly recommended for intensive applications when soldering is exposed to FOD environments
or for applications where the soldering iron works close to vertical position.
Note:
For the different
handles are different sealing plugs available.
Sealing Plug Replacement
Before replacing the sealing plug, unplug the power supply and make sure the device is not hot.
Note:
The chamfered side
has to be positioned towards
the handle.
2. Mounting Position
3. Inserting Sealing Plug
1. Removing Sealing Plug
Sealing
Plug
Handle
Push the sealing plug inside
the handle until the sealing
plug and handle edges are
aligned.
Enter, not deeper than 8mm,
a small shaft or screwdriver
and lift and pull the sealing
plug. Never use a cartridge to
do this operation.
Handels:
T245-A / T245-C / T245-GA T210-A / T210-NA T245-PA
T210-PA
Grip ref.:
0016057 (green)
0018658 (green) 0021528 (blue) 0023310 (blue)
Handels:
T245 / T470
T210
Sealing plug ref.:
OB2000 OB1000
6
