Operation
AC Console
The LEDs indicate the station’s different work-
ing modes.
1. Station without a tool connected:
The
green IN USE light flashes with the sequence
(- - -- --)
.
2. Tool out of the support:
The green IN
USE light is permanently lit, indicating that the
soldering iron tip is at working temperature.
3. Tool in the support (sleep mode):
The yel-
low SLEEP light is permanently lit. In order that
the tool goes into sleep mode, the tool must
be in its support and the programmed sleep
temperature must be less than the temp. on the
dial or the prefixed temperature.
4. Station with previously fixed temperature.
(Only for users of the AC console)
.
Soldering iron out of support:
- If the dial is above the prefixed temperature,
the green IN USE light is lit the majority of the
time, switching off briefly at regular intervals
(___ ___)
.
- If the dial is below the prefixed temperature,
the green IN USE light is off the majority of
the time, lighting up briefly at regular intervals
(- - -)
.
- If the dial is at the prefixed temperature, the
green light is permanently lit.
Errors
When the handpiece or the cartridge is in an
open circuit, the green IN USE light flashes with
the sequence
(- - - - - -)
.
When the handpiece or the cartridge is in a
short circuit, the green IN USE light flashes with
the sequence
(- - - - - - - - -)
.
If any of the above mentioned causes is corrected,
the station will start working automatically.
If the station is used continually in a overloaded
condition for a period of time, the system will
stop and both leds will flash simultaniusly.
Switch station off and on to reset and review
the soldering application.
Yellow LED
(SLEEP)
Green LED (IN USE)
Dial
The original parameters of control unit can be
modified using the
AC
console.
It is necessary to connect the console AC with
software revision 7.0 or later to the BT in order to
configure it
(consult JBC for console software updates).
Previous versions only allow for reading of
counters and do not allow for modification of
parameters.
Configuration possible:
- Fixing the working temperature.
- Selection of temperature units ºC or ºF.
- Modification of sleep temperatures and standby
times.
- Adjustment of temperature.
- Reset the parameters back to factory settings.
- Read-out data:
- Working hours.
- Sleep cycles and sleep hours.
- Cartridge and iron changes.
- Program version.
6
