JB Systems RF-DMX Converter, Руководство по эксплуатации

Страница: 9 / 43

ENGLISH OPERATION MANUAL
JB SYSTEMS
®
7/40 RF-DMX CONVERTER
The RF-DMX RECEIVER will send out 12 channels of switch pack.
The connected units should be always setup with the following start
addresses:

Unit1: start address = 001

Unit2: start address = 002

Unit3: start address = 003

Unit4: start address = 004

Unit5: start address = 005
 …

Unit12: start address = 012
Mode5 uses sticker M5 for the transmitter, the sticker layout has the following
buttons.
The remote has 12 identical toggle buttons and one blackout button:
1. Blackout: switches the output between 000 (output = off) and the last
value that has been set previously.
2. Toggle Button: Switch the unit on: DMX-value = 255
Switch the unit off: DMX-value = 000
MODE6: MAINLY FOR SCANNERS AND MOVING HEADS
Used to control light effects using 4ch DMX mode or 4chMSL DMX configuration
This mode allows the RF DMX converter to control light effects like the LED Pulsar, LED Microscan,
BT60LS, Sirius,…
All these products should be compatible with the MODE 6 of the RF-DMX converter independently on the
number of channels (1,2,3 or 4).
Even if the connected units don’t use 4 DMX-channels, the RF-DMX
RECEIVER will always send out 4channels. As result, the connected units should be always setup with the
following start addresses:

Unit1: start address = 001

Unit2: start address = 005

Unit3: start address = 009

Unit4: start address = 013
Mode 6 uses sticker M6 for the transmitter, the sticker layout has 4 group:
1. Blackout: switches the output between 000 (output = off) and the last value
that has been set previously.
2. Standby button: If you press this button, the RF-DMX converter will toggle
the standby mode of the selected unit depending on its previous state. If you
press the button more than 1s, the fixture will go in fast strobe mode.
3. Color-button: If you press this button, the RFDMX converter will change the
colors. If you press the button more than 1s, the fixture will use the original
colors of the show.
4. Gobo-button: If you press this button, the RF-DMX converter will change
the gobos. If you press the button more than 1s, the fixture will use the
original gobos of the show.
Dipswitch settings: 0110