JB-Lighting P9 Beamspot, Руководство по эксплуатации

Страница: 33 / 44

- 33 -
P9
8. Service
8.1 Service menu
RESET FIXTURE
Upon the “Reset” command, P9 Beamspot will initialise to its initial values. It is the same
procedure as after switching on the P9 Beamspot. If an error message appears in the display,
this could be the first step to correct it.
ERROR LIST
The P9 Beamspot stores all occurring errors internally. An error message can have a harmless
cause. If you experience frequent error messages, please contact your dealer or the JB-Lighting
service department. All error messages are displayed with the respective frequency and can be
deleted.
FUNCTION TEST
This function allows you to test all functions of the P9 Beamspot without using a light mixer. The
pan/tilt reset is deactivated in the process.
DMX TEST
This menu item is used to test the DMX input. Use the function keys to select the DMX channel
to be tested. The display shows the incoming value, at the same time the P9 Beamspot reacts
accordingly.
INIT PAN TILT
The P9 Beamspot is calibrated in the pan/tilt position at the factory. If it loses this calibration, i.e.
it strikes against the stop or no longer finds its position, it can be re-initialised using this function.
This process takes about 3-4 minutes and ends with a reset of the spotlight.
DISPLAY CONTRAST
The contrast of the LCD display may change when the temperature is too high. In this menu item
the contrast can be adjusted.
7.5.5 RDM sensor IDs
RDM sensor ID GET SET DISCO-
VERY
Note
RDM sensors
Temp Sens Base LCD
✔ ✔
Temp Sens Base PS
✔ ✔
Temp Sens Head PCB
✔ ✔
Temp Sens Head Drv
✔ ✔
Temp Sens Head LED
✔ ✔
Temp Sens Head Air
✔ ✔
Pan Tilt Speed
✔ ✔
Effect Speed
✔ ✔
Backlight Mode
✔ ✔
Disp Orientation
✔ ✔
Main Screen Mode
✔ ✔
Safe Mode Switch
✔ ✔
LED Fade Out Mode
✔ ✔