JB-Lighting LICON FX, Руководство пользователя

Страница: 72 / 89

12.02.2010 V1.0 -27-
Finally, the line below shows the speed of the chase in the AUTO mode expressed
either in seconds or hertz. The speed time is also used as a basis for scaling of the
fade time, if the fade time is a percentage value.
6.2 Storing chases
In order to store chases, you must first of all - in analogy to the storage of cues - set
the lighting state to be stored with the faders of the A/B section. This lighting state
may consist of single channels or of already programmed lighting states. It is
therefore of importance that the faders of the A/B fader sections have the desired
configuration. Take also in account that the position of the submaster faders will
influence the dimmer values to be stored (see
4.2 A/B fader sections
).
Enter the main menu and press the softkey
STORE
. The corresponding STORE LED
is activated.
Now select the storage destination for the chase by pressing the flash key of the
desired chase fader (
BANK A C1...C4
,
BANK B C1...C4
,
BANK C C1...C4
,
BANK
D C1...C4
).
The STORE LED is now flashing and the display as described under
6.1 Screen
display in the STORE and EDIT mode
is shown. If the storage destination is already
occupied by a chase (length L: non zero), you can delete this chase by pressing the
softkey
CLEAR
.
Cancelling of the storage process is only possible by pressing the
ESC
key.
For completion of the storage process, press the softkey
STORE
again and the
lighting state will be stored on the chase position currently selected.
The free position after the last chase step is the standard destination for storage of a
new chase step.
You can change the storage position of steps within the chase using the encoder.
This change is only possible, however, if the chase contains at least one step. If you
select an already existing step, this step will be overwritten by the lighting state to be
stored by pressing the softkey
STORE
With the softkey
INS
(insert) it is possible to insert the lighting state to be stored in
the currently selected position. Within the chase, all subsequent steps plus the step
currently selected will then be shifted backward by one position.
This chase is now on request on the corresponding chase fader, unless the fader
section of this fader is currently in the single channel access mode (see
4.2 A/B fader
sections
).
6.3 Editing chases
The EDIT mode will modify stored chase steps and chase parameters.
-> For quick start guide continue with
6.4 Modifying chase parameters
Enter main menu and, in analogy to editing cues, press the softkey
EDIT
to edit
chases. The corresponding LED is activated.
Select the chase to be edited by pressing the flash key of the desired chase fader
(
BANK A C1...C4
,
BANK B C1...C4
,
BANK C C1...C4
,
BANK D C1...C4
).
The display as described under
6.1 Screen display in the STORE and EDIT mode
is
shown with the following menu bar:
6.3.1 Deleting the entire chase
Press the softkey
CLEAR
to delete the entire chase.