Page
4
of
6
Assembly Instructions:
1.
Place the uprights onto a table or pair of saw horses and loosely assemble the
parts as shown.
2.
One upright will be designated the Winch End Upright and the other the Anchor
End Upright.
3.
Assemble the winch onto one of the uprights as shown.
4.
Carefully slide the bottom sliding collar and top roller collar onto the winch end upright.
Align the roller collar with winch assembly and tighten.
5.
Carefully slide both a bottom sliding collar and anchor end collar over the anchor end
upright. Do not over tighten the clamping bolts as further adjustment will be required.
6.
Place uprights in preinstalled sleeves (see instructions included with sleeves for their
installation).
7.
Adjust the heights of the collars to the specific activity to be played. The top edge of the
top collars should be placed about ¾” above the desired height of the net. The bottom
collars should be positioned about 39” below the top collars.
8.
Ensure both side dowels are inserted in the side net binding. Position the net between the
2 uprights.
9.
Thread the webbing strap from the winch over the roller clamp and connect the end of
the cable to the snap buckle. Connect the other end of the net to a carabiner and the
length of chain provided and attach that end of the chain to the top anchor end clamp
(step 5) with the other carabiner.
10.
Adjust the length of the chain as necessary to center net on court.
11.
Slowly tension the top webbing strap by cranking the winch with the winch
handle. Adjust chain as necessary to keep the net centered.
12.
Verify net heights and net centering. The uprights will deflect inward and downward due
to net tension; you may need to adjust heights and /or re-center the net.
13.
Tie one end of the bottom cord to the S-hook on one of the bottom sliding collars.
Thread the other end through the PVBNTH tensioning handle, as shown. Pull the
handle to draw the bottom cord taunt. Next, adjust the side straps on both ends of the
net so it is centered within the playing area.
