Stationary Wall Mounted Backstop - Installation & Operating Manual
N24GB / N46GB / N68GB / N810GB / N1012GB
www.jaypro.com / (800) 243-0533 / 976 Hartford Tpke, Waterford, CT 06385 USA
SUBJECT TO CHANGES IN DESIGN AND MANUFACTURING
COPYRIGHT 2019 JAYPRO SPORTS, LLC. ALL RIGHTS RESERVED
Sheet 13 of 18
INNOVATION, PERFORMANCE AND COMMITMENT SINCE 1953
ASSEMBLING THE UNIT
1. Prepare the wood stringers for installation by attaching all brackets with carriage bolts provided. Tighten
these sufficiently to cause the bolt to compress into the stringer. Use a speed square to ensure the brackets
are secured square.
2. Attach each stringer loosely, to allow for leveling. Level and tighten the stringers securely to the wall and
cut off excess bolts protruding from the wall. Maintain center-to-center dimensions and height requirements
as accurately as possible to make the rest of the installation as easy as possible.
3. Attach support chains to the stringers before attempting to assemble the frames, these are normally
needed to support the frames after raising them. It is easier to have them in place before proceeding.
4. Assemble each frame on the ground, including all XBAR frame bracing and the board mount
attachment fitting.
5. The next step is dependant on the chain
attachment location:
6. With both frames now installed, attach the backboard and height adjuster (if equipped) to the frame.
***IMPORTANT*** Always secure the board to the frame supported by the chains FIRST. Never attach the
board to the frame supported by the rachet straps.
The rachet straps should only see the weight of the
frame itself. With the board secured to the frame at all four corners, adjust the turnbuckles as needed and
remove the rachet straps.
7. Cut off any excess chain.
8. Install the rim and edge padding (if equipped).
9. Quite often, any wall anchors or bolted connections to wood stringers can become loose after the
anchors see loading. This is caused by the additional compression of the wood. Once final assembly is
complete, check all wall anchors and bolted connections for tightness.
A) If the chains are attached to the bottom frame
structure, as shown in Figure 2, attach the top frame
to the wood stringer(s). Use a rated rachet strap at
each side to hold the upper frame structure in the
approximate location. Next, install the bottom
frame structure to the wood stringer and support
the frame with the support chains and turnbuckle.
Adjust the turnbuckles to level the frame structure
and to evenly distribute the weight of the unit.
B) If the chains are attached to the top frame
structure, as shown in Figure 3, attach the top frame
to the wood stringer(s) and support the frame with
the support chain and turnbuckle. Adjust the
turnbuckles to level the frame structure and to
evenly distribute the weight of the unit. Next,
attach the lower frame to the wood stringer(s). Use
a rated rachet strap at each side to hold the upper
frame structure in the approximate location.
Figure 2: Lower Chain Supports
Figure 3: Upper Chain Supports
TEMPORARY RATCHET
STRAPS SUPPORTING
UPPER FRAME STRUCTURE
CHAIN SUPPORTING
LOWER FRAME
TEMPORARY RATCHET
STRAPS SUPPORTING
LOWER FRAME STRUCTURE
CHAIN SUPPORTING
UPPER FRAME
