Jayco SWIFT 2023, Руководство пользователя

Страница: 66 / 107

Section 8: Plumbing System
60
Fresh Water Holding Tank
Direct access to fill the fresh water tank is typically located in
the sofa base. The exact location of the fill may vary depend
-
ing on the model. Remove the cap for direct filling of the
water tank.
The fresh water tank can also be filled using the city tank fill
setting on the utility center.
To empty the fresh water tank, locate the drain valve under
the vehicle chassis close to the tank location. This will empty
the tank only. To drain the entire water system, the low point
drains must be used.
Water Heater Bypass
Most models have a factory installed water heater bypass
that enables you to avoid filling the water heater with RV
antifreeze. The 2-Valve Bypass is typically located in close
proximity to the water heater, and can be accessed through
the opening on top of the (driver side) sofa base. A and B
must be open to allow water into the water heater.
Normal Mode operation allows water to flow into the water
heater. Both hot and cold bypass valve handles should be
pointed toward the water heater connections.
operation diverts the flow of water around the water heater,
keeping water out of the water heater. Hot water bypass valve handle should point inline
with the (red) hot water outlet line. Cold water bypass valve handle should point inline with
the (blue) cold water inlet line.
 Do not cap, block or modify the fresh water tank overflow tubes in any
way. Enough water pressure can build up during the filling process to
damage the plumbing system if the overflow tubes are obstructed.
 Be careful not to overfill the fresh water holding tank. It can pressurize
the tank, causing leakage and water damage and void the warranty. DO
NOT leave the tank unattended while filling.
Table of Contents