Jayco REDHAWK 2023, Руководство пользователя

Страница: 89 / 141

83
Section 8: Plumbing System
Water Heater Switches
The water heater switches are typically located on the monitor panel. Refer to the Monitor
Panel section for function details.
™
NOTE: A short hose is supplied with your motor home for use in sanitizing
or winterizing the water lines in your RV. It can also be used to siphon fill the
fresh water tank when no city water is available. One end of this hose has a
fitting that will screw onto the city water connection inlet allowing the other
end to be put into a container of fresh water, sanitizer or RV antifreeze (refer
to
Sanitizing and Winterizing
).
™
If needed, sanitize the water system prior to travel.
The Plumbing System with Utility Center
Water valve settings indicated on the utility center label:
 City Fixtures
- Allows you to access water from all fau-
cets using a pressurized water source (referred to from
here on as “city water”).
 City Fill Tank - Allows you to fill your fresh water tank
using city water.
 Country Fill - Allows you to siphon fill your fresh water
tank (using the 12-volt water pump) when you do not
have access to city water.

Normal
- If the RV is not connected to city water, allows
you to pump water from the fresh water tank to
all faucets using the 12-volt water pump.
Sani-
tize/Winterize Lines
– Allows you to sanitize or
winterize the water lines.
 Sanitize Tank
– Allows you to sanitize the fresh
water tank. Depending on your model, the city
water connections may be configured one of three
ways:
1.
A water valve control panel (Fig A)
. The city water
connection inlet will be located on the outside of the
motor home, and the pump switch inside on the moni-
tor panel.
2.
A horizontal utility center (Fig B
). This utility center
contains the city water connection inlet, pump switch,
water valve controls, outside shower, black tank flush
inlet and a macerator discharge system.
Fig. B - Utility Center
Table of Contents Maintenance Record