![background image](http://html1.mh-extra.com/html/jayco/qwest/qwest_owners-manual_3668740035.webp)
Closing Your Folding Camping Trailer
INSIDE
1. Enter folding camping trailer and remove canvas from screen door by pulling canvas
away from channel, beginning at the TOP of door, proceeding to bottom. (Fig. 3-12)
2. Swing screen door up to roof and latch the twist locks. (Fig. 3-10)
3. Zip all windows closed.
4. Roll all privacy drapes to the ceiling by pressing both buttons on either side of the
black locks and drawing the locks upward.
5. Remove bow braces from bracket on the roof and pull brace to center of camping
trailer. Remove from saddle peg on bed bow. Place bows under bed mattress.
6. Remove stove.
OUTSIDE
7. Raise the stabilizer jacks (Fig. 3-5) to their upright position. Insert the crank and
turn counterclockwise until the jack is tight, then turn the crank an additional 1/8 of
a turn (snug tight).
8. Unfasten Velcro bed flaps.
CAUTION:
DO NOT push bed in until ALL Velcro is detached. Push bed in
COMPLETELY before beginning to lower roof. Failure to push the bed in com-
pletely BEFORE lowering roof can damage tent components. Your Jayco Limited
Warranty does not cover this damage.
9. Remove straight bed braces and push beds in carefully and completely.
10. Remove curved bed braces. Place all braces under bed mattresses carefully. (Fig. 3-6)
11. Lower roof half to two-thirds down. Reach inside and distribute awning panel of tent
and drape EVENLY across beds.
12. Continue to lower roof until final 6-8" (10-15 cm). Using both hands and arms, push
tent from each side, front and rear, into the center of camper evenly and carefully
continue to lower roof.
13. Attach roof latches to clips. Due to air pockets, the roof may need to be pushed
down with your hand the last 1-2" (3-5 cm).
14. Before removing crank, tighten cable system by turning crank in the “UP” movement
to make it taut taking caution not to overtighten. This will place slight tension on the
cable system and avoid cables becoming loose and entangled.
CAUTION: It is very important to place tension on the cable system to prevent
them from becoming tangled. If the cables become tangled, it could lead to breakage
of the lifter cables when the roof is raised.
15. Remove crank and place in storage area inside folding camping trailer.
16. Fasten roof latches.
27
Содержание Qwest
