Jayco PINNACLE FIFTH WHEELS 2019, Руководство пользователя

Страница: 100 / 185

98
Section 6: Electrical System
The shore power cord is designed to continuously carry the 50-amp current flow required to
power each leg of the electrical system. It also creates a critical ground connection between
the vehicle electrical system and the campground shore power receptacle.
Always test the external power source (i.e., the campsite power receptacle or electrical box)
with a ground monitor before connecting your power cord to it. If the ground monitor indi-
cates ‘reverse polarity’ or an ‘open ground’,
DO NOT connect the power cord.
Regularly inspect the shore power cord for cuts, cracks, worn insulation and other damage.
Have the power cord replaced immediately if problems exist.
Calculating 50 AMP Electrical Load (if so equipped)
When connecting appliances to the electrical system, remember that 120-volt power usage is
limited to 50 amps per electrical system leg for a total of 100 amps. Each operating appliance
collectively places an added load on your 120-volt electrical system.
An unintentional “trip” of a circuit breaker may occur if you overload the recreation vehicle
and/or campground electrical system. The amperage rating of individual appliances can be
calculated by dividing appliance wattage consumed (normally listed on the appliance) by
nominal design voltage (120 for a 120-volt appliance). For example: 1200 watts divided by
120-volts equals 10 amps.
Generator
The factory-installed generator will produce 120-volt AC power for use when camping in
areas where shore power is unavailable. 120-volt power from the generator is output to the
AC distribution center by way of a factory-installed automatic transfer switch. In the default
mode, the automatic transfer switch connects the generator to the AC distribution center
when the generator is operating and shore power is disconnected.
Before Starting the Generator
1. Make sure the carbon monoxide detector is working.
2.
Turn “off” air conditioners and all other appliances.
3. Check for fuel, exhaust and coolant leaks.
STOP the generator immediately if there is a fuel, exhaust or coolant leak and have it
repaired!
Maintenance Record Table of Contents