![background image](http://html1.mh-extra.com/html/jayco/mini-motorhome/mini-motorhome_owners-manual_3661256037.webp)
28
9. Allow to stand for at least three hours.
10. Drain the water tank and water heater completely by turning on all faucets until tank
and heater are empty.
11. Connect the garden hose to the city water connection and fill the tank.
12. Open kitchen and bathroom faucets to allow air to escape the water lines and the
water heater.
13. Turn the pump on and allow several seconds for the pump to prime.
14. After the water heater and water lines fill, the air will stop bubbling out of the
faucets. At this point, turn all faucets off. Please note, the water heater will hold
approximately six gallons (22.7 liters) of water. Allow the water to run long enough
to ensure that the tank is full.
15. Allow to stand for at least three hours.
To remove excessive chlorine odor and taste:
1. In a large bucket, prepare a solution of ½ cup baking soda to one gallon (3.78
liters) of water for every 15 gallons (56.78 liters) of tank capacity.
Repeat steps 3-8 above.
2. Allow the baking soda solution to sit in the tank for a few days while traveling or
allow to stand for a few days.
Repeat steps 10-14 from above.
3. Drain the water tank and water heater completely by turning all faucets on until
tank and heater are empty.
4. Your demand water system is now ready for use.
Units with Utility Center:
1. Drain the water tank and water heater completely by turning all faucets on until tank
and heater are empty.
2. In a large bucket prepare a chlorine solution using ¾ cup of household bleach and
three (3) gallons (11.35 liters) of water.
3. Place the “Clear Hose” in a bucket of solution. (Fig. 4-6)
4. Turn “Fresh Water Valve” to normal position.
5. Turn “Winterizing Valve” to “Sanitize/Winterize Intake.”
6. Close the “Water System Valve” located behind the water pump. (Fig. 4-7)
7. Open the “Bypass Hose Valve.” (Fig. 4-7)
8. Close the “Low Point Drain Valve.” (Fig. 4-7)
9. Turn the “Water Pump Switch” to the “ON” position and allow all of the chlorine
solution to enter the tank. (Fig. 4-6)
10. After allowing all the chlorine solution to enter the tank, turn the “Winterizing
Valve” to normal.
11. Turn “Fresh Water Inlet Valve” to fill water tank position.
12. Open the “Water System Valve.” (Fig. 4-7)
13. Close the “Bypass Hose Valve.” (Fig. 4-7)
14. Connect garden hose to the “Fresh Water Inlet” and add water until the tank is ½-¾
full. (Fig. 4-6)
Содержание Mini Motorhome
