83
Section 6: Electrical System
Awning Operation:
Select the AWNING icon; the
screen opens showing the awnings (
Fig 6
). If there
are multiple awnings, there will be a selection for each
awning at the left of the screen. Select the awning you
want to control, then press and hold the
EXTEND
(B)
or
RETRACT
(C) buttons. Select the back arrow (A)
to return to the Device Selection screen
Leveler Operation:
Select the LEVELING icon, the
screen opens showing the Leveler Control screen (
Fig
7
). This screen will allow you to extend and retract
the jacks and to auto level the RV. Press the
AUTO
LEVEL
button (A) to begin leveling the RV.
Refer to the Lippert User Guide for the One Control
system for more detailed information. Select the
HOME icon (upper right) to return to the Device Se-
lection screen.
Slide-out Operation:
Select the SLIDES icon which
will open the Slideout screen (
Fig 8
). The screen can
display up to 4 slideouts. Slideouts will be numbered
1-4 on the touchscreen. Press Slide 01, and then press
(and hold) the
OUT
(A) button to extend the slide, or
the
IN
(B) button to retract it. Repeat this action on
the remaining slideouts. Select the back ar-
row to return to the Device Selection screen.
IMPORTANT SAFETY FEATURE: IF
SLIDE 01 IS MISSING FROM THE
LIST:
This indicates there is a problem with the bed-
room slide-out. In order for the slideout to
function properly, the bedroom door
MUST
BE OPEN
. An electronic door catch has been
installed to the wall in the bedroom behind
the door (
Fig 9
). A
second piece is mounted to the door (
Fig 10
). If the door is closed, the Slide 01 notification
on the touchscreen display will disappear and the slide-out will NOT operate. When the
bedroom door is opened and the catch pieces connect, the Slide 01 notification appears on
the touchscreen display and the slide-out can then be operated normally.
DSI FLT - Direct Spark Ignition Fault (if so equipped):
This light above the GAS water
heater switch on the Command Center panel indicates a problem with the LP portion of the
water heater. When the GAS switch is turned on, the light will blink quickly 3 times and the
water heater will ignite. The light should then stay OFF. If the light comes on and stays
on, it indicates the gas side of the water heater has not fired and there is a problem with the
igniter. There is no water heater switch on the app screen.
NOTE:
This same safety feature applies to the slide-out switch on the wall
or on the Command Center switch panel. The bedroom door must be open
and the catch pieces connected for the bedroom slide to work.
Table of Contents
Maintenance Record
Содержание JAY FLIGHT BUNGALOW Towables 2021
