![background image](http://html1.mh-extra.com/html/jayco/jay-flight-bungalow-2009/jay-flight-bungalow-2009_owners-manual_3624375068.webp)
SECTION 9
SLIDEOUT SYSTEM
64
After the slideout is
extended, verify that the
corners of the black
rubber seal are set up
correctly. The corners of
this seal are cut at a 45°
angle. The top of the
seal must overlap the
side of the seal to avoid
the possibility of water
penetration.
Retracting slideout room
Press the IN section of the slideout control
switch and hold it until the motor stops.
Operating the switch after the room is fully
retracted will damage the switch and motor.
Maintenance
Your slideout system has been designed to
require very little maintenance. To ensure a
long life of your slideout system, read,
understand and follow these simple
instructions. This system contains a pre-lubed
bearing that is lubricated when the room is
moved in and out. Do not spray oil or grease
on the rails while the room is extended.
T
ROUBLESHOOTING
T
HE
S
LIDEOUT
If the slideout does not move when the
slideout switch is depressed, follow these
steps.
Check the auxiliary battery (customer
supplied) for a full charge and good wire
connections.
Check the 12-volt fuse or circuit breaker.
Check for loose connections at the
slideout motor.
If the slideout still will not operate, follow
these steps.
If the slideout is extended, refer to the
following section on overriding the specific
slideout system installed on your park
trailer.
If the slideout is retracted, leave it in that
position.
Contact your dealer or Jayco Customer
Service for repair assistance.
If the slideout extends crooked or only one
side moves, follow these steps.
Follow steps on overriding the specific
slideout system installed on your park
trailer.
You may need to push the side that is not
sliding to get it to retract all the way.
Contact your dealer or Jayco Customer
Service for repair assistance.
Dexter Chassis Group (V-tech) slideout
override
If the park trailer has an
underbelly, locate and
remove the access panel
to access the slideout
motor (this panel is
typically under the park
trailer on the opposite
side of the slideout
room). Use a 3/4 socket
and ratchet on the hex head located on the
end of the drive shaft. Turn the drive shaft
until the slideout is in the position you desire.
Contact your Dealer for service.
Fig. 9.3 Exterior
slideout corner
Do not work on your system unless the 12-
volt DC (auxiliary battery, customer
supplied) and 120-volt AC electrical
systems (shore line power cord) have
been disconnected.
Fig. 9.4 V-tech
slide hex head
Содержание Jay Flight Bungalow 2009
