Jayco Hummingbird Towables 2019, Руководство пользователя

Страница: 125 / 165

Section 8: Plumbing System
123
Please contact your RV dealer for assistance in the purchase and installation of a sewer hose
or sewer hose extension (if needed).
Sewage (black) tank preparation:
1. Release one to two quarts (1 or 2 liters) of water into the toilet bowl.
2. Follow the directions on your (RV approved) toilet chemical bottle (customer sup-
plied), by placing the recommended quantity of holding tank chemical into the toilet
bowl.
3.
Flush the toilet and allow at least two gallons (8 liters) of water to flow into the holding
tank.
Waste (grey) holding tank preparation:
No special preparation is required, however, placing a small quantity of chemicals into this
tank, such as baking soda or an approved RV chemical, will reduce odors from food particles
in the system.
Cleaning and Maintenance:
The toilet should be cleaned regularly for maximum sanitation and operational efficiency.
Use only RV approved chemicals. Do not use chlorine (undiluted) or caustic chemicals,
such as laundry bleach or drain opening types, in the toilet system. These products damage
the seals in toilets and dump valves.
It is important to add enough water to prevent solid waste buildup. Follow the
directions listed below and in the manufacturer’s operator manual.

Black Tank Flush (if so equipped)
The black tank flush (no fuss flush) inlet is typically located on the utility
center panel. The location may vary depending on your model. The inlet
color may be either white or black. Attach a garden hose (connected to
a pressurized fresh water source) to the black tank flush inlet. The water
goes directly into the black water holding tank sprayer connection, al-
lowing you to remove debris and preventing accumulation. There is a
check valve in the plumbing lines to prevent back flow.Flush the black
water tank each time the grey and black water holding tanks are dumped
or as needed.
1. Dump the black water tank (see
Gray Tank Drain & Black Tank
Drain ) and leave the black tank drain valve open.
2.
Connect a garden hose from the water supply source to the black tank flush.
3.
With the water source turned ON, flush the black water holding tank until the water
running out of the black tank drain valve is clear (not discolored or cloudy).
4. Disconnect the garden hose and close the black tank drain valve. Fasten the sewer hose
housing dust cap back on the tank flush inlet.
Tank Flush Inlet
Table of Contents Maintenance Record