Jayco EAGLE FW HT 2020, Руководство пользователя

Страница: 140 / 201

Section 8: Plumbing System
138
4. Run water through all faucets (hot and cold, including outside shower and outside
kitchen) until chlorine smell is gone. Turn all faucets and outside shower off, turn pump
OFF.
5.
Drain the fresh water system again. If the RV has the full system canister water filter,
remove the canister, reinstall the filter, and reattach the canister.
6.
Refill the fresh water tank with fresh water again and when water heater is full of water,
turn the water heater power ON. Water heater is full if you open a
HOT
water faucet
and water comes out in a steady stream.
Lingering Chlorine Taste:
If a chlorine taste lingers in the water,
flush the water system with a solution consisting of one-quart vinegar
to five gallons of clean water. Re-flush as necessary. The vinegar
solution may damage the water heater or the water filter. Remove the
canister water filter and bypass the water heater.
Set water heater
bypass lever to BYPASS
(pointing up).
Follow the steps outlined in Draining the Fresh Water System with
one exception:
do not drain the water heater. Do not remove the
water heater drain plug.
For the
full system canister water filter: remove the canister, take out
the filter, then re-attach the empty canister.
After draining the system:
1. For a tank type (storage) water heater, the power should still be OFF (both electric and
LP Gas switches).
2. Put the vinegar solution into the fresh water tank.
Set the colored valves to the
SANITIZE
setting.

Green valve points left

Blue valve points down
Attach a short hose to the SANITIZE/WINTERIZE inlet. Put the
other end of the hose in a container with the vinegar solution. Do
NOT
use your fresh water hose for this.
Turn the water pump ON. The solution will be drawn into the fresh water tank When
the container is empty, turn pump OFF, and disconnect hose from utility panel.
To aid in siphoning, place the container approximately (2) feet off the ground. The
drain valves must be closed.
3. Fill the fresh water tank full of clean (potable) water. Use water either from a pressur-
ized source, or from a container (as detailed in Step 18).
4. Set the valves to the
DRY CAMPING
setting. Turn the pump ON to
send water through the lines. Run water through all faucets (hot and
cold, including outside shower and outside kitchen if applicable)
until chlorine smell is gone.
5. Close all faucets including outside shower and outside kitchen (if
applicable). Turn pump OFF.
6. Drain the system again, but do not drain the water heater (water heater power still OFF
and water heater is bypassed).
7. Close low point drains and fresh water tank drain.
8.
Refill the fresh water tank with clean potable water. Use the CITY WATER CONNEC
-
TION inlet or SANITIZE/WINTERIZE inlet depending on which fill method you use
explained in Step 18 previously.