![background image](http://html1.mh-extra.com/html/jayco/class-c2013-greyhawk/class-c2013-greyhawk_owners-manual_3516008084.webp)
SECTION 8 -
P
LUMBING SYSTEM CLASS C MOTOR HOME
GH/M 8 - 8
Replacing the water filter cartridge
Replace the water filter cartridge at least once a year.
1. Drain the fresh water system.
2. Place a container beneath the water cartridge filter to catch any spillage.
3. Unscrew the fittings at the top and bottom of the water filter cartridge. Pull the
water filter cartridge down and out of the fittings.
4. Insert the new water filter cartridge and tighten the fittings securely by hand.
Dispose of the used water cartridge filter.
For more information
Refer to the manufacturer’s owners manual and the label on the water filter
cartridge.
D
RAINING
T
HE
F
RESH
W
ATER
S
YSTEM
To drain the fresh water holding tank and supply lines:
1. Open all faucets, including the outside shower faucet.
2. Open the “fresh tank drain” valve.
All permanent fresh water tanks can be drained by one of
two types of drain valve:
A white plastic drain is attached to the exterior wall (open
valve to drain) or a valve located inside the motor home
adjacent to the water tank (this knob turns 45° to open or
close).
3. Open the “low point drains” by turning,
then pulling the handles up.
As their name indicates, they will be at the lowest point of
water lines. A label is placed on the outside of the RV to
indicate where the drains are located. The drains will typically
need to be opened from inside the motor home. Once the
label is found on the exterior sidewall, go inside the motor
home to find the corresponding location of the drains.
4. Turn ON the water pump and allow it to run as needed.
5. Operate the toilet flush lever until water stops flowing.
6. Relieve the water pressure using the P&T valve BEFORE removing the water
heater drain plug.
7. Otherwise, if there is any water pressure present the water will spray out of
the opening when the drain plug is removed.
When you are finished draining the fresh water system, reverse these steps and
dump the grey and black water holding tanks at an appropriate facility or according
to local public codes.
U
TILITY
C
ENTER
The following information defines the function of the utility center settings
indicated on the utility center label:
City Fixtures
- This setting allows you to access water at all faucets using city
water.
Fig. 8.3
Exterior
fresh water
d
i
Fig. 8.4 Low
point drains
Содержание CLASS C2013 GREYHAWK
