Jayco 2013 JAY FEATHER TOWABLES, Руководство пользователя

Страница: 68 / 134

SECTION 5 - SLIDEOUT SYSTEM JAYCO TOWABLE
5-2
Retracting slideout room
Press the IN section of the slideout control switch and hold it until the motor stops.
Operating the switch after the room is fully retracted will damage the switch and
motor.
Maintenance
Your slideout system has been designed to require very little maintenance. To
ensure a long life of your slideout system, read, understand and follow these
simple instructions. This system contains a pre-lubed bearing that is lubricated
when the room is moved in and out. Do not spray oil or grease on the rails while
the room is extended.
T
ROUBLESHOOTING
T
HE
S
LIDEOUT
If the slideout does not move when the slideout switch is depressed, follow
these steps.

Check the auxiliary battery (customer supplied) for a full charge and good
wire connections.

Check the 12-volt fuse or circuit breaker.

Check for loose connections at the slideout motor.
If the slideout still will not operate, follow these steps.

If the slideout is extended, refer to the following section on overriding the
specific slideout system installed on your RV.

If the slideout is retracted, leave it in that position.

Contact your dealer or customer service for repair assistance.
WARNING
Do not work on your system unless the 12-volt DC (auxiliary battery, customer
supplied) and 120-volt AC electrical systems (shore line power cord) have
been disconnected.
Fig. 5.2 Slideout overlap