Jayco 2013 Eagle, Руководство пользователя

Страница: 64 / 134

SECTION 4 TOWING & SET-UP JAYCO TOWABLE
4-18 JFSTT/JFXTT
Condensation can be prevalent if proper ventilation is not used. It can exist
whether or not a heater is used. We recommend that you leave a small opening in
each bunk zipper to permit air to flow through and allow the tent to “breathe.” This
will help minimize moisture gathering above the bunk area on the vinyl (see
Condensation).
Closing the beds

NOTE: The front bed mat will be the easiest place to store the side and rear
bed bow braces. Starting with the front bed will enable you to take the bed bow
braces off of the rear and side and immediately store them. Caution should be
taken to place the bed bow braces in the mat with the curved part down to prevent
the bed bow brace ends from damaging the mat.
Front bed
1.
Remove the bunk mat from the front bed platform, set aside. Make sure all
loose items have been removed from the bunk mat and bed platform. Items
left in these areas may cause damage to the mats and tent.
2.
Loosen the hinge cover by lifting up on the Velcro side. Lay the cover back
on the bed shelf.
3.
Remove the bed bow brace from the ceiling by pushing in on the exposed
button and pulling down. Pull the bed bow towards you and remove the C-
shaped connector from the bed bow. Set the bed bow brace aside.
4.
From the exterior, lift the bottom of the tent up exposing the bed platform.
Fold the tent in towards the center of the bed platform.
5.
Make sure the bed tent is pushed in at least 1” above the side bulb seal.
6.
Lift the bed up and hold it in a vertical position. Tuck the tent in on both sides.
Make sure the top of the door is clear from obstructions.
7.
Latch one side of the door.
8.
From the interior, inspect the perimeter of the door making sure there is
nothing obstructing the top and sides of the door. Make sure the hinge cover
is clear of the door.