Jayco 2012 Jay Feather Ultralite, Руководство пользователя

Страница: 34 / 94

SECTION 4
TOWING & HANDLING JAYCO TOWABLE
When attaching wires to your tow vehicle,
carefully and tightly tape all the connections
for moisture protection.
White 1 Ground
Blue 2
Brakes
Green 3 Running lights
Black 4 Auxiliary battery charge line
Red 5 Stop & left turn
Brown 6 Stop & right turn
Yellow 7 Back up
The connector plug may build up corrosion
with extended use and should be cleaned
periodically to insure good electrical contact.
Make sure the connector plug is kept clean
and protected from road elements as you
travel.
S
TABILIZER
J
ACKS
1. Each stabilizer jack can be individually
adjusted to stabilize the trailer for use.
2. When setting your RV up on soft
ground, you may wish to place a wood
pad or the equivalent under each
stabilizer jack foot. This will help keep
the stabilizer jack from sinking into the
ground.
3. To lower each jack, insert the jack
crank onto the applicable stabilizer
jack shaft.
4. Turn the crank clockwise to lower
each leg until it contacts the ground
and stabilizes the trailer.
To raise each jack, insert the jack crank onto
the applicable stabilizer jack shaft and turn
the crank counter-clockwise.
The stabilizer jacks must be fully retracted
before moving or towing the RV to prevent
stabilizer jack damage.
T
RAVEL
T
RAILER
H
ITCHING
P
ROCEDURE
Fig. 4.2
The following procedure will help to assist you
in securely hooking up your RV to your tow
vehicle.
7-way trailer
plug
Car end, rear
view
1. Make sure the trailer wheels are blocked.
2. Turn the tongue jack crank to raise the
travel trailer tongue above the hitch ball.
3. Open the coupler latch on the travel trailer
hitch.
4. Back the tow vehicle into the proper
position.
5. Turn the tongue jack crank to lower the
coupler onto the hitch ball.
6. Close the coupler latch after it is
completely seated.
7. Install the (customer supplied) weight
distributing bars (equalizers) as directed
by the OEM.
8. Remove the dolly wheel or platform and
retract the tongue jack to its maximum
height.
9. Attach the breakaway switch cable to the
tow vehicle.
10. Attach the safety chains.
11. Plug in your wire harness/connector plug
from the tow vehicle to the travel trailer.
12. Walk around the RV to verify exterior
lights are working correctly.
13. Remove the trailer wheel blocks.
DO NOT USE THE STABILIZER JACKS
TO LEVEL THE RV.
It is important to
remember that the stabilizer jacks are to be
used only for support while occupying and
moving around the RV. They are not
designed to bear the weight of the RV.
4 - 2