Jayco 2011 pinnacle, Руководство пользователя

Страница: 55 / 97

SECTION 7
PLUMBING SYSTEMS
5. Move the valves to the “Sanitize Tank”
position. The low point drains must be
closed for the chlorine solution to siphon
through the lines.
6. Turn the water pump ON.
If the water pump fails to self-prime,
temporarily open the low point drains
(close the low point drains as soon as the
water pump primes [chlorine solution will
begin draining out] and before continuing
to the next step).
7. After the recommended amount of
solution is in the tank, turn OFF the water
pump.
8. Turn the “water heater bypass” valve to
the NORMAL position.
9. Continue filling the fresh water tank with
clean (potable) water until it is full.
10. Open the hot water line on all the faucets
(kitchen, lavatory, shower and outside
shower) until water begins to flow
continuously and a chlorine smell is
noticeable.
11. Close the hot water lines and repeat with
the cold water lines on the faucets.
12. Let the solution remain in the system for at
least four hours when disinfecting with 50-
PPM residual chlorine.
If a shorter time period is desired, then a
100-PPM chlorine concentration should be
permitted to sit in the system for at least
one hour.
13. After the required period, drain the
chlorine solution from the fresh water
system (see draining the fresh water
system).
Some solution may remain in the water
heater and will be flushed in the following
steps:
14. Fill the fresh water system completely full
using clean (potable) water (see fresh
water connections) completely full.
15. Then, drain the fresh water system (see
draining the fresh water system).
If a chlorine taste lingers in the water, flush
the water system with a solution consisting of
one-quart vinegar to five gallons of clean
water. Re-flush as necessary.
W
INTERIZING
T
HE
P
LUMBING
S
YSTEM
Preparing your RV for colder weather or
storage is very important for most states and
Canada. Failure to prepare your RV may
cause water supply lines and the water heater
to freeze. No commodity or product should be
added to the fresh water system to ensure
freeze protection other than RV antifreeze.
The RV should be winterized at the end of the
camping season or when the RV will be
exposed to temperatures that will fall at or
below 32°F (0°C). Repairs due to freezing are
not warrantable.
There are two methods of winterizing your
trailer based upon your model. Please read,
understand and follow all instructions before
beginning.
Air pressure (all models)
This method will utilize an air hose to blow
excess water from the water lines.
1. Make sure all holding tanks are empty and
drain valves OPEN.
2. Run the water pump until it is dry, this will
take approximately 15-20 seconds.
3. OPEN all faucets and drains, and the
toilet.
4. Using an air hose and adapter (customer
supplied), blow air through the city water
connection. Any remaining water will blow
out in five to ten minutes.
5. Pour one cup of non-toxic RV antifreeze
into all drain P-traps.
Automotive antifreeze (ethylene glycol) and
windshield washer antifreeze (methanol)
are poisonous. Never use these products
in your fresh water system. These products
are harmful and may be fatal if swallowed.
51