SECTION 6
ELECTRICAL SYSTEM - 30 AMP
amps per hour. This does not include any 12-
volt lights, water pump or any other 12-volt
component.
If the furnace and refrigerator in the
above example operated constantly, a
75 amp-hour battery would become
fully discharged in 5 hours (75ah / 15a
= 5h).
The auxiliary battery should be installed in
parallel with the battery in your tow vehicle.
When the 7-way trailer plug is connected,
both batteries power the RV so it is important
not to discharge your tow vehicle battery
below the level required to start the engine.
To prevent this from occurring, disconnect the
7-way trailer plug or install a battery isolator.
When the tow vehicle engine is operating with
the RV connected, the tow vehicle charging
system will charge both batteries.
Battery storage instructions
Replacement and maintenance
Some equipment in your RV will draw small
amounts of current even when turned OFF.
To prevent the auxiliary battery from being
discharged when your RV is not connected to
shore line power, disconnect the auxiliary
battery negative cable at the battery. During
storage, it is important to check the voltage
monthly and recharge the auxiliary battery as
needed. If you remove the auxiliary battery
from your RV, store it in a dry, cool area per
the OEM instructions.
When it is time to replace the auxiliary battery,
replace it with a Group 27 deep cycle battery
only. Contact the battery OEM for further
information. Do not reverse the positive and
negative battery cables (doing so will blow the
reverse polarity fuse(s) that protect the
converter).
B
ATTERY
I
SOLATOR
F
OR
Y
OUR
T
OW
V
EHICLE
(C
USTOMER
S
UPPLIED
)
You may want to consider the installation of a
battery isolator on your tow vehicle as a
convenience feature:
□
It receives current from the tow vehicle
alternator and controls distribution of
energy to both the auxiliary battery and
the tow vehicle battery.
□
It serves as a check valve to prevent
energy from being drawn from your tow
vehicle chassis battery (so you can start
your tow vehicle engine).
Your dealer can assist you with the selection,
purchase and installation of this aftermarket
part.
12-
VOLT
F
USE
P
ANEL
The 12-volt fuse panel is labeled to indicate
the fuse sizes, positions and components
powered. At the beginning of camping
season, inspect all the 12-volt fuses and
replace as needed.
Replacing a fuse
Before replacing a fuse, always turn OFF the
electrical component(s) protected by it.
1. Disconnect the power cord.
2. If so equipped, disconnect the auxiliary
battery negative cable at the battery.
3. Remove the fuse panel cover to check
fuses.
4. Pull the fuse straight out of the fuse block.
If the fuse is not blown, something else
must be causing the problem. Please
contact your dealer for further assistance.
5. Insert a new fuse of the same specified
voltage, amperage rating and type in the
original location.
Never use a higher
rated replacement fuse.
The fuse panel label should be kept
permanently affixed to your RV. The fuses will
not offer complete protection of the RV
electrical system in the event of a power
surge or spike.
Replacement fuses must be of the same
voltage, amperage rating and type. Never
use a higher rated replacement fuse; doing
so may cause a fire by overheating the RV
wiring.
43
Содержание 2010 Jay Flight
