![background image](http://html1.mh-extra.com/html/jayco/2004-talon-zx/2004-talon-zx_owners-manual_635967046.webp)
12 Volt DC Demand Pump
When water is desired and you are not hooked up to city water, you
need to turn on 12 volt DC power to start the demand pump. Fig. 4-2
shows a typical demand pump set up. Depending on your sport utility
trailer model, the demand pump will be located under the bed, in a
cupboard, or under the sink. The switch to operate the pump is located
on the monitor panel. Energy for the pump is supplied by the auxiliary
battery or converter. The pump will self prime when started and
provide water for your sport utility trailer. The pump continues to run
until approximately forty pounds of pressure is achieved and
automatically starts again when pressure drops to twenty pounds.
Some cycling in the pump may occur, depending on the volume of water being released. A check
valve is built inside of the pump to prevent water from flowing into supply tank.
Note: The water pump switch should be in the off position when the camper is left
unattended for any amount of time. If something would happen to the water system,
this will ensure that water damage will be restricted to a small area.
Sanitizing and Filling the Potable Water System
Potable water systems require periodic maintenance to deliver a consistent flow of fresh water.
Depending on use and the environment the system is subject to, sanitizing is recommended prior to
storing and before using the water system after a period of storage. Systems with new components,
or ones that have been subjected to contamination, should also be disinfected as follows:
1. Use one of the following methods to determine the amount of common household bleach
needed to sanitize the tank.
• Multiply "gallons of tank capacity" by 0.13; the result is the ounces of bleach needed to
sanitize the tank.
• Multiply "liters of tank capacity" by 1.0; the result is the milliliters of bleach needed to
sanitize the tank.
2. Mix the proper amount of bleach into a container of water.
3. Pour the solution (water/bleach) into the tank and fill the tank with potable water.
4. Open all faucets (Hot and Cold) allowing the water to run until the distinct odor of chlorine is
detected.
5. The standard solution must have four (4) hours of contact time to disinfect completely.
Doubling the solution concentration allows for contact time of one (1) hour.
6. When the contact time is completed, drain the tank. Refill with potable water and purge the
plumbing of all sanitizing solution.
If there is a problem of excessive chlorine odor and taste after the sanitizing process, follow the
above procedures using a solution of baking soda (1/2 cup added to one gallon (4 liters) of water per
15 gallons (60 liters) of tank capacity) or vinegar (one quart added to five gallons (20 liters) of water
per 15 gallons (60 liters) of tank capacity.)
Your demand water system is now ready for use.
36
Talon Owner’s Manual
Fig. 4-2
Содержание 2004 Talon ZX
