INSTALLATION
Plug the AC/DC adaptor to an AC household outlet, and then plug the DC jack to the back of the unit.
Your clock radio is ready to work for you.
BACKUP BATTERY INSTALLATION
Your clock radio requires one CR2032 lithium battery (not included) to provide backup power to the
clock in the event of a temporary power interruption.
1.
Place your unit face down on a flat surface.
2.
Slide and remove the battery cover at the bottom of your unit.
3.
Insert one CR2032 lithium battery into the battery compartment with the “+” side facing up as
indicated.
4.
Replace the battery cover.
If AC power is interrupted, the LED display will go off and both the radio and the alarm will not function.
The backup battery will keep the time and all settings of your unit. Make sure a fresh CR2032 lithium
battery is used. A fresh CR2032 battery could backup your clock continuously for around 3 days.
SETTIMG TIME, 12/24HR TIME AND THE SNOOZE DURATION
1.
Press
SET
once, the hour digits flash. Press or to set the current hour (hold to advance
rapidly).
2.
Press
SET
again, the minute digits flash. Press or to set minutes.
3.
Press
SET
again, the display shows “
24Hr
” and flashes, Press or to select “
12Hr
” or
“
24Hr
” time format.
4.
Press
SET
again, the display shows “
05
” and flashes, Press or to select your snooze
time from 5 to 60 minutes.
5.
Press
SET
again or if no key pressed for approx. 10 seconds to exit the setting mode.
Note: when 12-hour time format is selected, the
P
(PM) icon will appear on the lower middle time
display to indicate the afternoon time; there is no AM indicator.
SETTING THE ALARMS
1.
Press
AL 1.2
once, the
A1
icon and the hour digits flash. Press or to set the alarm 1
hour.
2.
Press
AL 1.2
again to adjust minutes. Press or to set the alarm 1 minutes.
3.
Press
AL 1.2
again, LED displays “
OFF
” (alarm off). To select wake to sound sources, press
or to select :-
rd
= wake-by-radio
bu
= wake-by-buzzer
OFF
= alarm off
4.
Press
AL 1.2
again, the
A2
icon and the hour digits flash. Press or to set the alarm 2
hour. Repeat step 2) and 3) to set alarm 2.
5.
Press
AL1.2
again or no button around 10 seconds to exit alarm setting mode. When wake-
to-radio or wake-to-buzzer is selected, the related alarm is turned on, indicated by
appearance of the
A1
and / or the
A2
icon on the left side of the display.
