/DC SELECT:
ON/OFF/DC Voltage Selection Key
/DC SELECT:
Press to switch on the equipment and press the key to
select DC output voltage.
DC output voltage can be switched between DC 12 V and DC 19V. When
switching voltages, selected voltage is flashing. After pressing “DIM/ENTER”
key to confirm, the voltage character stops flashing, and DC outlet outputs
corresponding voltage.
To switch off the equipment, press“
/DC SELECT
” key for at at least 3
seconds.
Note: There is no DC output under flashing status.
DIM /ENTER:
LCD Backlight switch/DC voltage selection confirmation key In
ON mode, press “DIM/ENTER” key to switch on/off backlit. Under voltage
regulation status, press “DIM/ENTER” key to confirm currently selected
voltage.
Torch ON/ OFF
Press the Torch ON/ OFF button for about 3 seconds to turn on the torch.
After the torch is on, press the torch switch key to switch between “ON”,
“SOS” and “OFF” mode.
Under “ON” Status, press the torch switch key for about 3 seconds in
order to turn off the torch.
LED Warning Light Switch
The LED Warning Light is to warn the other vehicles not to collide with the
accident vehicle when the truck has failure. It can also be used as a lighting
device when repairing the truck.
Press the LED warning light switch for about 3 seconds to turn on the
LED warning light function.
The default setting is “traffic fault warning.
Press the key and choose the preferred model including traffic fault
warning”,“White lighting” and “OFF” mode.
Press the key for about 3 seconds in order to turn off the LED warning
light
To Jump Start a truck
Mode Definition:
Traffic Fault Warning:
The red LED flashes twice followed by twice flashing
of white LED and then the same cycle repeats.
SOS:
The light flashes in the cycle of triple short flashing---triple long
flashing—triple short flashing and then the same cycle repeats.
Note: Turn off the LED warning light by pressing the switch for at
least 3seconds when the it is not in use in order to extend the life of
battery.
Warning:
Warning:
The product is for 24V vehicles. Do NOT connect it with 12V
vehicle to avoid any damage.
Jump-starting a truck can cause serious injury. If you are
unsure how to operate the equipment, please do not attempt
to jump-start your vehicle. Pls contact a qualified person for
assistance.
The product is for you to jump start the truck when the 24V battery is in
insufficient voltage, low temperature status or the truck cannot be started.
To jump start the truck, insert the starting output line into the EC5 interface
(positive pole is red and negative pole is black). Clamp the red alligator clip,
which is the positive pole of output line, on the positive pole of 24V battery,
and black alligator clip, which is the negative pole of output line, on the
negative pole of truck battery. If the connection is correct, LCD display of the
product will display a sign meaning the battery of the product is connected
with the battery of the truck and everything is ready. The built-in buzzer will
alarm twice with long buzzing. Then two continuous short "beep" sounds are
alarmed every two seconds to inform user the status is ready, please start
the truck right away. If the connection is reverse or the contact is unreliable,
it may result the product cannot be started automatically.
5
6
